RM35X0E _58 Vehicle Interior _079257 SUPPLEMENTAL RESTRAINT SYSTEMS _0385611 SIDE AIRBAG SENSOR(for Rear Pillar) A

SUPPLEMENTAL RESTRAINT SYSTEMS SIDE AIRBAG SENSOR(for Rear Pillar) INSTALLATION

CAUTION / NOTICE / HINT

HINT:: ·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

PROCEDURE

Hide Display 89831C 1.INSTALL NO. 2 SIDE AIRBAG SENSOR

a.

Check that the ignition switch is off.

b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:: ·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.

c.

for Van:

i.

B524643

Attach the claw and hold the No. 2 side airbag sensor in place.

NOTICE:: ·

If the No. 2 side airbag sensor has been dropped, replace it with a new one.

·

When installing the No. 2 side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

d.

for Wagon:

i.

B550087

Attach the guide and hold the No. 2 side airbag sensor in place.

NOTICE:: ·

If the No. 2 side airbag sensor has been dropped, replace it with a new one.

·

When installing the No. 2 side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

e.

Install the bolt.

Torque:: 9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:: Tighten the bolt while holding the No. 2 side airbag sensor because the No. 2 side airbag sensor claw is easily damaged.

f.

Check that there is no looseness in the installation parts of the No. 2 side airbag sensor.

g.

Connect the airbag connector.

NOTICE:: When connecting any airbag connector, take care not to damage the airbag wire harness.

HINT:: Refer to How to Connect or Disconnect Airbag Connector:; ·

for Type B:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR201902,999999,_58,_079257,_0385034,RM100000001GNBX,

·

for Type C:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR201906,999999,_58,_079257,_0396679,RM100000001IJ8B,

Hide Display 89831J 2.INSTALL NO. 4 SIDE AIRBAG SENSOR (for Wagon)

a.

Check that the ignition switch is off.

b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:: ·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.

c.

B550088

Attach the guide and hold the No. 4 side airbag sensor in place.

NOTICE:: ·

If the No. 4 side airbag sensor has been dropped, replace it with a new one.

·

When installing the No. 4 side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

d.

Install the bolt.

Torque:: 9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:: Tighten the bolt while holding the No. 4 side airbag sensor because the No. 4 side airbag sensor claw is easily damaged.

e.

Check that there is no looseness in the installation parts of the No. 4 side airbag sensor.

f.

Connect the airbag connector.

NOTICE:: When connecting any airbag connector, take care not to damage the airbag wire harness.

HINT:: Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR201906,999999,_58,_079257,_0396679,RM100000001IJ8B,

Hide Display 62632D 3.INSTALL REAR QUARTER TRIM BOARD LH (for Van)

Click hereVehicle Interior>INTERIOR PANELS / TRIM>SIDE PANEL>INSTALLATION201906,999999,_58,_078375,_0381232,RM100000001JPT0_02_0001,

Hide Display 73370E 4.INSTALL REAR SEAT OUTER BELT ASSEMBLY LH (for Van)

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY (for Van)>INSTALLATION201902,999999,_58,_078602,_0387530,RM100000001GXUA_01_0261,

Hide Display 62520B 5.INSTALL QUARTER TRIM PANEL ASSEMBLY LH (for Wagon)

HINT:: When removing and installing the No. 2 side airbag sensor or No. 4 side airbag sensor installed on the driver side, perform this procedure.; Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Wagon)>INSTALLATION201906,999999,_58,_078375,_0396474,RM100000001IHQ6_01_0021,

Hide Display 62510M 6.INSTALL QUARTER TRIM PANEL ASSEMBLY RH (for Wagon)

HINT:: When removing and installing the No. 2 side airbag sensor or No. 4 side airbag sensor installed on the passenger side, perform this procedure.; Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Wagon)>INSTALLATION201906,999999,_58,_078375,_0396474,RM100000001IHQ6_01_0019,

Hide Display 67872A 7.INSTALL NO. 1 SLIDE DOOR WEATHERSTRIP LH (for Wagon)

a.

Return the No. 1 slide door weatherstrip LH to its original position.

HINT:: Use the same procedure described for the RH side.; Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR OPENING TRIM WEATHERSTRIP (for Wagon)>INSTALLATION201906,999999,_59,_078503,_0397541,RM100000001IPZ5_02_0003,

Hide Display 67935 8.INSTALL BACK DOOR SCUFF PLATE (for Wagon)

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>INSTALLATION201906,202208,_58,_078375,_0381233,RM100000001IXV5_01_0010,202208,999999,_58,_078375,_0381233,RM1000000024I1A_01_0010,

Hide Display 67881A 9.INSTALL BACK DOOR WEATHERSTRIP (for Wagon)

Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR WEATHERSTRIP>INSTALLATION201902,999999,_59,_078503,_0385655,RM100000001GNFW,

Hide Display 73570A 10.INSTALL NO. 3 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) (for Wagon, w/ Seat Belt)

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY (for Wagon)>INSTALLATION201906,999999,_58,_078602,_0398109,RM100000001IT6F_06_0005,

Hide Display 73233 11.INSTALL OUTER LAP BELT ANCHOR COVER (for Wagon, w/ Seat Belt)

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY (for Wagon)>INSTALLATION201906,999999,_58,_078602,_0398109,RM100000001IT6F_06_0009,

Hide Display 12.INSTALL REAR SEAT ASSEMBLY (for Wagon)

·

for Folding Seat:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Folding Type)>INSTALLATION201902,999999,_58,_078601,_0382458,RM100000001G55V,

·

for Manual Captain Seat:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Manual Captain Seat)>INSTALLATION201906,999999,_58,_078601,_0396327,RM100000001IY38,

·

for Power Captain Seat:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Power Captain Seat)>INSTALLATION201906,999999,_58,_078601,_0396328,RM100000001IGZK,

Hide Display 13.INSTALL REAR NO. 3 SEAT ASSEMBLY (for Wagon)

·

for 60/40 Split Seat Type 40 Side:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for 60/40 Split Seat Type 40 Side)>INSTALLATION201906,999999,_58,_078601,_0396039,RM100000001IFKV,

·

for 60/40 Split Seat Type 60 Side:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for 60/40 Split Seat Type 60 Side)>INSTALLATION201906,999999,_58,_078601,_0396040,RM100000001IFL0,

Hide Display 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

·

for 7GR-FKS:

Click hereGeneral>MAINTENANCE>7GR-FKS BATTERY>INSTALLATION201902,999999,_V1,_078672,_0387105,RM100000001GV7O,

·

for 1GD-FTV:

Click hereGeneral>MAINTENANCE>1GD-FTV BATTERY>INSTALLATION201902,999999,_V1,_078672,_0387106,RM100000001H6FS,

Hide Display 15. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE201906,999999,_V1,_081196,_0393338,RM100000001JBY9,

HINT:: When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.; Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART201906,999999,_V1,_081196,_0393338,RM100000001IWEY,

Hide Display 16.PERFORM DIAGNOSTIC SYSTEM CHECK

·

for Type B:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>DTC CHECK / CLEAR201902,999999,_58,_079257,_0385034,RM100000001GJPZ,

·

for Type C:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>DTC CHECK / CLEAR201906,999999,_58,_079257,_0396679,RM100000001IJ88,

Hide Display 17.CHECK SRS WARNING LIGHT

·

for Type B:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>OPERATION CHECK201902,999999,_58,_079257,_0385034,RM100000001GJPW,

·

for Type C:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>OPERATION CHECK201906,999999,_58,_079257,_0396679,RM100000001IJ85,

Hide Display 18.PERFORM SYSTEM INITIALIZATION AND CALIBRATION

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SIDE AIRBAG SENSOR (for Rear Pillar)>REMOVAL201906,999999,_58,_079257,_0385611,RM100000001IIS2,