Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL CLIP
If the clip is removed, do not reuse it.
Perform this procedure only when removal/installation of the clip is necessary.
Attach the claw and install a new clip.
89837A
2.INSTALL REAR FLOOR SIDE AIRBAG SENSOR
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Attach the guide and hold the rear floor side airbag sensor in place.
Install the bolt.
Tighten the bolt while holding the rear floor side airbag sensor because the rear floor side airbag sensor guide is easily damaged.
Check that there is no looseness in the installation parts of the rear floor side airbag sensor.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR201906,999999,_58,_079257,_0396679,RM100000001IJ8B,
89839A
3.INSTALL REAR FLOOR SIDE AIRBAG SENSOR COVER
If the rear floor side airbag sensor cover is removed, do not reuse it.
Peel off the release sheet.
Do not touch the silicon coated surfaces of the tape.
Install a new rear floor side airbag sensor cover.
58513F
4.INSTALL NO. 3 FLOOR MAT
58570C
5.INSTALL REAR FLOOR CARPET ASSEMBLY
Return the rear floor carpet assembly to its original state.
6.INSTALL SEAT TRACK RAIL PROTECTOR
58595
7.INSTALL NO. 3 FLOOR CARPET MOULDING NO. 1
58595
8.INSTALL NO. 3 FLOOR CARPET MOULDING NO. 2
9.INSTALL REAR SEAT TRACK SLIDE STOPPER
62510M
10.INSTALL QUARTER TRIM PANEL ASSEMBLY RH
67871E
11.INSTALL NO. 1 SLIDE DOOR WEATHERSTRIP RH
Return the No. 1 slide door weatherstrip RH to its original position.
67935
12.INSTALL BACK DOOR SCUFF PLATE
67881A
13.INSTALL BACK DOOR WEATHERSTRIP
73560A
14.INSTALL NO. 3 SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR) (w/ Seat Belt)
Use the same procedure described for the LH side.
73233
15.INSTALL OUTER LAP BELT ANCHOR COVER (w/ Seat Belt)
16.INSTALL REAR SEAT ASSEMBLY
for Manual Captain Seat:
for Power Captain Seat:
17.INSTALL REAR NO. 3 SEAT ASSEMBLY
for 60/40 Split Seat Type 40 Side:
for 60/40 Split Seat Type 60 Side:
18.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
19. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
20.PERFORM DIAGNOSTIC SYSTEM CHECK
21.CHECK SRS WARNING LIGHT
22.PERFORM SYSTEM INITIALIZATION AND CALIBRATION