Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
84234
1.REMOVE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
for Semi-trim:
Using a T30 "TORX" socket wrench, remove the "TORX" screw and rear door courtesy light switch assembly.
Disconnect the connector.
for Full-trim:
Using a T30 "TORX" socket wrench, remove the "TORX" screw and rear door courtesy light switch assembly.
Disconnect the connector.
2.REMOVE REAR SEAT ASSEMBLY
Perform this procedure only when replacing the courtesy light wire.
for Commuter, 3-Passenger Seat with 2-Point Type Seat Belt and Headrest:
for Commuter, 3-Passenger Seat with 2-Point Type Seat Belt without Headrest:
for Commuter, 3-Passenger Seat with 3-Point Type Seat Belt:
for Commuter, 4-Passenger Seat:
for Commuter, Single-Passenger Seat with 2-Point Type Seat Belt:
for Commuter, Single-Passenger Seat with 3-Point Type Seat Belt:
for Commuter, 2-Passenger Seat with 2-Point Type Seat Belt:
for Commuter, 2-Passenger Seat with 2-Point Type Seat Belt and Headrest:
for Commuter, 2-Passenger Seat with 2-Point Type Seat Belt without Headrest:
3.REMOVE REAR SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR) (for Full-trim)
Perform this procedure only when replacing the courtesy light wire.
Use the same procedure described for the LH side.
4.REMOVE REAR SEAT OUTER BELT ASSEMBLY RH (for Van)
Perform this procedure only when replacing the courtesy light wire.
Use the same procedure described for the LH side.
67935
5.REMOVE BACK DOOR SCUFF PLATE (for Full-trim)
Perform this procedure only when replacing the courtesy light wire.
74733
6.REMOVE NO. 1 HAND GRIP COVER (w/ Hand Rail)
Perform this procedure only when replacing the courtesy light wire.
74708
7.REMOVE NO. 2 HAND GRIP FRAME SUB-ASSEMBLY (w/ Hand Rail)
Perform this procedure only when replacing the courtesy light wire.
8.REMOVE REAR DOOR SCUFF PLATE RH (for Full-trim)
Perform this procedure only when replacing the courtesy light wire.
74617A
9.REMOVE ASSIST GRIP PLUG (for Full-trim, w/ Assist Grip)
Perform this procedure only when replacing the courtesy light wire.
74680
10.REMOVE PILLAR ASSIST GRIP ASSEMBLY C (for Full-trim, w/ Assist Grip)
Perform this procedure only when replacing the courtesy light wire.
62631D
11.REMOVE REAR QUARTER TRIM BOARD RH (for Semi-trim)
Perform this procedure only when replacing the courtesy light wire.
Use the same procedure described for the LH side.
62630L
12.REMOVE REAR QUARTER TRIM BOARD ASSEMBLY RH (for Full-trim)
Perform this procedure only when replacing the courtesy light wire.
62610K
13.REMOVE SIDE TRIM BOARD ASSEMBLY RH (for Full-trim, High Roof)
Perform this procedure only when replacing the courtesy light wire.
82351B
14.REMOVE COURTESY LIGHT WIRE
Perform this procedure only when replacing the courtesy light wire.
Disconnect the 2 connectors and remove the courtesy light wire.