Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
73920B
1.INSTALL FRONT SEAT AIRBAG ASSEMBLY LH
Install the front seat airbag assembly LH with 2 new nuts.
Do not reuse the nut.
Attach the wire harness clamp.
2.INSTALL FRONT SEATBACK COVER WITH PAD
3.INSTALL FRONT SEATBACK ASSEMBLY
Attach the guide and install the front seatback assembly to the front seat cushion assembly.
Temporarily install the front seatback assembly with the 4 bolts.
Tighten the 4 bolts.
Attach the claw and clamp.
Attach the claw first.
Connect the connector.
Attach the hook.
w/o Front Seatback Board:
Attach the band.
Install the 3 clips.
71705G
4.INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)
|
Install in this Direction |
Attach the hook and install the front seatback board sub-assembly LH as shown in the illustration.
Install the 2 screws.
Attach the band.
Install the 3 clips.
71812T
5.INSTALL FRONT SEAT CUSHION SHIELD LH (for Driver Side)
71862K
6.INSTALL FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)
71861K
7.INSTALL FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
71811T
8.INSTALL FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)
71849J
9.INSTALL FRONT SEAT NO. 3 ADJUSTER COVER CAP LH (for Driver Side)
72526H
10.INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
72551L
11.INSTALL RECLINING HINGE COVER LH
72495A
12.INSTALL FRONT SEAT VERTICAL ADJUSTER HANDLE LH (for Driver Side)
13.INSTALL FRONT SEAT ASSEMBLY LH
14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
15. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
16.PERFORM DIAGNOSTIC SYSTEM CHECK
17.CHECK SRS WARNING LIGHT
18.PERFORM SYSTEM INITIALIZATION AND CALIBRATION