The side collision sensor RH circuit consists of the airbag sensor assembly, No. 1 side airbag sensor RH and rear floor side airbag sensor.
The rear floor side airbag sensor detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the SRS should be deployed.
DTC B1675 is stored when a malfunction is detected in the rear floor side airbag sensor or airbag sensor assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Test Mode / Check Mode |
|---|---|---|---|---|---|
| B1675 | Rear Floor Airbag Sensor | Either condition is met:
·
A rear floor side airbag sensor malfunction. ·
An airbag sensor assembly malfunction. |
·
Rear floor side airbag sensor ·
Airbag sensor assembly |
Comes on | Not applicable |
After the engine switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
When disconnecting and reconnecting the battery
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
After replacing the airbag sensor assembly, refer to initialization.
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Replace the rear floor side airbag sensor.
Perform the inspection using parts from a normal vehicle if possible.
| Proceed to |
|---|
| NEXT |
NEXT
| *1 | Rear Floor Side Airbag Sensor |
| *2 | No. 1 Side Airbag Sensor RH |
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Clear the DTCs in memory.
Turn the engine switch off.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Check for DTCs.
| Proceed to |
|---|
| DTC B1675 is not output |
| DTC B1675 is output |
Codes other than DTC B1675 may be output at this time, but they are not related to this check.
DTC B1675 is not output
DTC B1675 is output