The steering sensor*1 or combination switch ECU sub-assembly*2 receives the turn signal switch information and controls the turn signal lights.
*1: w/ VSC
*2: w/o VSC
for LHD
for RHD
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / Steering Angle Sensor / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Turn Signal Switch (Right) | Turn signal switch (right turn position) signal | OFF or ON | OFF: Turn signal switch not in right turn position
ON: Turn signal switch in right turn position |
- |
| Turn Signal Switch (Left) | Turn signal switch (left turn position) signal | OFF or ON | OFF: Turn signal switch not in left turn position
ON: Turn signal switch in left turn position |
- |
| Cornering Light/Front Side Illuminate Light Switch | Turn signal switch (full turn) signal | OFF or ON | OFF: Turn signal switch not in left or right full turn position
ON: Turn signal switch in left or right full turn position |
- |
| Tester Display |
|---|
| Turn Signal Switch (Right) |
| Turn Signal Switch (Left) |
| Cornering Light/Front Side Illuminate Light Switch |
Normal conditions listed above are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the turn signal switch.
Inspect the turn signal switch.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the steering wheel switch housing.
Inspect the steering wheel switch housing.
| Proceed to |
|---|
| OK (w/ VSC) |
| OK (w/o VSC) |
| NG |
OK (w/ VSC)
OK (w/o VSC)
NG