The side collision sensor LH circuit consists of the airbag sensor assembly, No. 3 side airbag sensor LH and side airbag pressure sensor LH.
The No. 3 side airbag sensor LH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the SRS should be deployed.
These DTCs are stored when a malfunction is detected in the No. 3 side airbag sensor LH or airbag sensor assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Test Mode / Check Mode |
|---|---|---|---|---|---|
| B1672 | Rear Door Side Airbag Sensor LH | Either condition is met:
·
A No. 3 side airbag sensor LH malfunction. ·
An airbag sensor assembly malfunction. |
·
No. 3 side airbag sensor LH ·
Airbag sensor assembly |
Comes on | Not applicable |
| B1684 | Lost Communication with Rear Door Side Airbag Sensor LH | Either condition is met:
·
A No. 3 side airbag sensor LH malfunction. ·
An airbag sensor assembly malfunction. |
·
No. 3 side airbag sensor LH ·
Airbag sensor assembly |
Comes on | Not applicable |
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
When disconnecting and reconnecting the battery
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
After replacing the airbag sensor assembly, refer to initialization.
| *1 | No. 3 Side Airbag Sensor RH |
| *2 | Airbag Sensor Assembly |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the No. 3 side airbag sensor LH with RH and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in memory.
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs.
| Proceed to |
|---|
| DTC B1672 or B1684 is output |
| DTC B1657 or B1673 is output |
| DTCs B1657, B1672, B1673 and B1684 are not output |
Codes other than DTC B1657, B1672, B1673 and B1684 may be output at this time, but they are not related to this check.
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Return the No. 3 side airbag sensor RH and LH to their original positions and connect the connectors to them.
DTC B1672 or B1684 is output
DTC B1657 or B1673 is output
DTCs B1657, B1672, B1673 and B1684 are not output