SUPPLEMENTAL RESTRAINT SYSTEMS AIRBAG SYSTEM B009E83 Right Side Restraints Sensor 5 Value of Signal Protection Calculation Incorrect
DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | DTC Output from | Priority | Test Mode / Check Mode |
|---|---|---|---|---|---|---|---|
| B009E83 | Right Side Restraints Sensor 5 Value of Signal Protection Calculation Incorrect | ·
Side airbag pressure sensor RH malfunction ·
Airbag sensor assembly malfunction |
·
Side airbag pressure sensor RH ·
Airbag sensor assembly |
Comes on | SRS Airbag | A | Does not apply to test/check mode |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
- NOTICE:
- ·
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
·When disconnecting and reconnecting the auxiliary battery.
- HINT:
-
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
·After replacing the airbag sensor assembly, refer to work procedure.
PROCEDURE
Pre-procedure1
Turn the ignition switch to ON, and wait for at least 60 seconds.
Procedure1
Check for DTCs.
- Body Electrical > SRS Airbag > Trouble Codes
- 50001 444
- Result:
Result Proceed to B009E83 is output A B009E83 is not output B
Post-procedure1
None
A
B
Pre-procedure1
Turn the ignition switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.
Procedure1
Check that the connectors are properly connected to the airbag sensor assembly and side airbag pressure sensor RH.
- OK:
The connectors are properly connected.
- Result:
Proceed to OK NG
Post-procedure1
None
OK
NG
Pre-procedure1
| *1 | Side Airbag Pressure Sensor LH |
| *2 | Airbag Sensor Assembly |
| *3 | Wire Harness |
Interchange the side airbag pressure sensor RH with LH and connect the connectors to them.
Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Procedure1
Clear the DTCs stored in memory.
- Body Electrical > SRS Airbag > Clear DTCs
- 50002 444
- Result:
Proceed to NEXT
Post-procedure1
Turn the ignition switch off.
NEXT
Pre-procedure1
Turn the ignition switch to ON, and wait for at least 60 seconds.
Procedure1
Check for DTCs.
- Body Electrical > SRS Airbag > Trouble Codes
- 50001 444
- Result:
Result Proceed to B009E83 is output A B009B83 is output B B009B83 and B009E83 are not output C
- HINT:
-
Codes other than DTCs B009B83 and B009E83 may be output at this time, but they are not related to this check.
Post-procedure1
Turn the ignition switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.
Return the side airbag pressure sensor LH and RH to their original positions and connect the connectors to them.
A
B
C