The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
except NR Series Engine:
for NR Series Engine:
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
for HV Model:
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Front Camera System | Drive the vehicle straight ahead at 15 km/h (9 mph) or more for 1 second or more. | ( 202304,999999,_95,_139716,_0584193,RM1000000029F4C,)
|
for Gasoline Model:
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Stop and Start System | Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted | ( 201906,999999,_51,_080774,_0393362,RM100000001HXHC,)
|
| Pre-collision System | Perform steering sensor zero point calibration | ( 202304,999999,_95,_139716,_0601175,RM100000002BFOE,)
|
| Lane Tracing Assist System | ||
| Front Camera System | Drive the vehicle straight ahead at 15 km/h (9 mph) or more for 1 second or more. | ( 202304,999999,_95,_139716,_0584193,RM1000000029F4C,)
|
1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
2.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
73240
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
Disengage each clamp.
Remove the nut and front seat inner belt assembly.
|
Remove in this Direction |
Remove the front seat belt anchor plate as shown in the illustration.
73230
4.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
Disconnect the connector under the front seat assembly.
Disengage each clamp.
Remove the nut and front seat inner belt assembly.
|
Remove in this Direction |
Remove the front seat belt anchor plate as shown in the illustration.