RM3660EC _53 Suspension _080780 TIRE PRESSURE MONITORING _0592791 TIRE PRESSURE WARNING SYSTEM(for Gasoline Model (for Type B)) J

TIRE PRESSURE MONITORING TIRE PRESSURE WARNING SYSTEM(for Gasoline Model (for Type B)) Tire Position Not Identified

DESCRIPTION

The tire pressure warning ECU and receiver identifies the tire position for each tire pressure warning valve and transmitter according to the wheel speed signals from the skid control ECU (brake actuator assembly) and acceleration rate signal from each acceleration sensor built into each tire pressure warning valve and transmitter.

CAUTION / NOTICE / HINT

NOTICE:: ·

When replacing the tire pressure warning ECU and receiver, first use the GTS to record all of the current IDs and registered tires with transmitters (4 or 5 tires) of the tire pressure warning valve and transmitter registered to the tire pressure warning ECU and receiver.

·

It is necessary to perform initialization after registration of the transmitter IDs into the tire pressure warning ECU and receiver if one of the valve and transmitters has been replaced.

for Registration:

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM (for Gasoline Model (for Type B))>REGISTRATION202304,999999,_53,_080780,_0592791,RM100000002AHU7,

for Initialization

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM (for Gasoline Model (for Type B))>INITIALIZATION202304,999999,_53,_080780,_0592791,RM100000002AHU8,

PROCEDURE

1.IDENTIFY TIRE POSITION FOR EACH TIRE PRESSURE WARNING VALVE AND TRANSMITTER

Set the tire pressure to the specified value.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION202304,999999,_53,_080781,_0392688,RM100000002B8QX,

Display the "ID Tire Inflation Pressure" value for each wheel using the GTS.

Chassis > Tire Pressure Monitor > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
ID 1 Tire Inflation Pressure	ID1 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm², 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm², 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm², 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm², 55 psi)	Actual tire inflation pressure	Not displayed, if data has not been received.*
ID 2 Tire Inflation Pressure	ID2 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm², 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm², 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm², 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm², 55 psi)	Actual tire inflation pressure	Not displayed, if data has not been received.*
ID 3 Tire Inflation Pressure	ID3 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm², 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm², 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm², 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm², 55 psi)	Actual tire inflation pressure	Not displayed, if data has not been received.*
ID 4 Tire Inflation Pressure	ID4 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm², 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm², 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm², 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm², 55 psi)	Actual tire inflation pressure	Not displayed, if data has not been received.*

HINT:: ·

*: It may take a few minutes until the values are displayed.

·

The wheel position cannot be determined from ID1 through ID4 on the Data List.

Chassis > Tire Pressure Monitor > Data List

Tester Display
ID 1 Tire Inflation Pressure
ID 2 Tire Inflation Pressure
ID 3 Tire Inflation Pressure
ID 4 Tire Inflation Pressure

50003 452 10,11,12,13

Rapidly reduce the tire pressure for each wheel at least 40 kPa (0.4 kgf/cm², 5.8 psi) within 30 seconds.

NOTICE:: ·

It may take a few minutes until the values are displayed.

·

When an "ID Tire Inflation Pressure" value has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the value.

Read the "ID Tire Inflation Pressure" value and identify the tire with reduced pressure, and record the corresponding tire pressure warning valve and transmitter (ID1 to ID4).

Repeat for each tire.

Set the tire pressure to the specified value.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION202304,999999,_53,_080781,_0392688,RM100000002B8QX,

Result:

Proceed to
NEXT

2.PERFORM INITIALIZATION

Leave the vehicle with the engine switch turned off for 15 minutes or more.

HINT:: After the vehicle has been stopped for 15 minutes or more, the tire pressure warning valve and transmitter will transmit radio wave signals more frequently for the first several minutes of driving (4 times more frequent than usual).

Perform initialization to clear the existing tire position information.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM (for Gasoline Model (for Type B))>INITIALIZATION202304,999999,_53,_080780,_0592791,RM100000002AHU8,

Result:

Proceed to
NEXT

3.IDENTIFY TIRE POSITION DURING DRIVING

Drive the vehicle at 40 km/h (25 mph) or more for 10 to 30 minutes in 1 trip.

HINT:: Do not drive the vehicle in reverse gear while performing Tire Position Identification. If the vehicle is driven in reverse gear while performing Tire Position Identification, identification information will be discarded and Tire Position Identification may take longer than usual.

Without turning off the engine switch, check the tire position for each transmitter.

Chassis > Tire Pressure Monitor > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
ID 1 Tire Position	ID1 Tire Position	No Information or FL or FR or RL or RR or Spare or Judging	ID1 tire position is displayed	If no tire position information is stored, "No Information" will be displayed.
ID 2 Tire Position	ID2 Tire Position	No Information or FL or FR or RL or RR or Spare or Judging	ID2 tire position is displayed	If no tire position information is stored, "No Information" will be displayed.
ID 3 Tire Position	ID3 Tire Position	No Information or FL or FR or RL or RR or Spare or Judging	ID3 tire position is displayed	If no tire position information is stored, "No Information" will be displayed.
ID 4 Tire Position	ID4 Tire Position	No Information or FL or FR or RL or RR or Spare or Judging	ID4 tire position is displayed	If no tire position information is stored, "No Information" will be displayed.

Chassis > Tire Pressure Monitor > Data List

Tester Display
ID 1 Tire Position
ID 2 Tire Position
ID 3 Tire Position
ID 4 Tire Position

50003 452 66,67,68,69

Result:

Result	Proceed to
A transmitter with its tire position as "Judging" exists.	A
No transmitter with its tire position as "Judging" exists, and no tire pressures are displayed on the multi-information display.	B
No transmitter with its tire position as "Judging" exists, and tire pressures are displayed on the multi-information display.	C

4.CHECK TIRE PRESSURE WARNING VALVE AND TRANSMITTER

GO TO TIRE PRESSURE WARNING LIGHT CIRCUIT INSPECTION PROCEDURE

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM (for Gasoline Model (for Type B))>Tire Pressure Warning Light Circuit202304,999999,_53,_080780,_0592791,RM100000002AHU5,

HINT:: Perform "Tire Pressure Warning Light Circuit" inspection to check the communication status between the combination meter assembly and tire pressure warning ECU and receiver.

END

4.CHECK TIRE PRESSURE WARNING VALVE AND TRANSMITTER

Without turning off the engine switch, check each transmitter with its tire position displayed as "Judging".

According to the display on the GTS, display the "ID Tire Inflation Pressure" item of the Data List.

Chassis > Tire Pressure Monitor > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
ID 1 Tire Inflation Pressure	ID1 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm², 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm², 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm², 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm², 55 psi)	Actual tire inflation pressure	Not displayed, if data has not been received.*
ID 2 Tire Inflation Pressure	ID2 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm², 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm², 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm², 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm², 55 psi)	Actual tire inflation pressure	Not displayed, if data has not been received.*
ID 3 Tire Inflation Pressure	ID3 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm², 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm², 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm², 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm², 55 psi)	Actual tire inflation pressure	Not displayed, if data has not been received.*
ID 4 Tire Inflation Pressure	ID4 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm², 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm², 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm², 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm², 55 psi)	Actual tire inflation pressure	Not displayed, if data has not been received.*

HINT:: *: It may take a few minutes until the values are displayed.

Chassis > Tire Pressure Monitor > Data List

Tester Display
ID 1 Tire Inflation Pressure
ID 2 Tire Inflation Pressure
ID 3 Tire Inflation Pressure
ID 4 Tire Inflation Pressure

50003 452 10,11,12,13

Result:

Result	Proceed to
Displayed	A
Not displayed	B

5.CHECK FREQUENCY RECEIVING CONDITION

REPLACE CORRESPONDING TIRE PRESSURE WARNING VALVE AND TRANSMITTER

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING VALVE>REMOVAL202304,202307,_53,_080780,_0392678,RM100000002B6S9,202307,999999,_53,_080780,_0392678,RM100000002CWJZ,

5.CHECK FREQUENCY RECEIVING CONDITION

Check that the following conditions are not met:

Facilities or devices that use similar radio frequencies are located in the vicinity of the vehicle.

ii.

Devices using similar radio frequencies are used in the vehicle.

OK:: Facilities or devices that use similar radio frequencies are not located in the vicinity of the vehicle.

HINT:: Radio wave transmissions may be interrupted due to the surroundings or devices installed by the user.

Result:

Proceed to
OK
NG

IDENTIFY TIRE POSITION DURING DRIVING AGAIN

CHECK IF ANY DEVICE IS INSTALLED BY USER