RM3660EC _56 Audio / Visual / Telematics _080753 TELEMATICS _0397006 TELEMATICS SYSTEM(for Gasoline Model) C

TELEMATICS  TELEMATICS SYSTEM(for Gasoline Model)  B15CB11  Telephone Main Antenna Circuit Short to Ground  B15CB13  Telephone Main Antenna Circuit Open  


DESCRIPTION

If an open or short circuit in the navigation antenna assembly is detected continuously for 1 minute as a result of a terminal check performed by the telematics transceiver every minute after the engine switch is turned on (IG), these DTCs will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15CB11 Telephone Main Antenna Circuit Short to Ground Navigation antenna assembly impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the engine switch is on (IG) (Short circuit)
·

Navigation antenna assembly

·

Antenna cord sub-assembly

·

Telematics transceiver


B15CB13 Telephone Main Antenna Circuit Open Navigation antenna assembly impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the engine switch is on (IG) (Open circuit)
·

Navigation antenna assembly

·

Antenna cord sub-assembly

·

Telematics transceiver



WIRING DIAGRAM

E360069E24
0.125,1.219 2.25,1.469 2.125,0.25 10 false Navigation Antenna Assembly 0.125,1.042 0.448,1.25 0.323,0.208 10 false D 5.646,0.969 5.969,1.177 0.323,0.208 10 false C 5.646,1.167 7.135,1.479 1.49,0.313 10 false Telematics Transceiver 3.604,0.719 3.854,0.927 0.25,0.208 10 false * 0.854,2.281 3.063,2.573 2.208,0.292 10 false *: Antenna Cord Sub-assembly 1.156,0.438 1.406,0.646 0.25,0.208 10 false 1 5.927,0.427 6.177,0.635 0.25,0.208 10 false 1

CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the telematics transceiver, refer to Service Bulletin.



PROCEDURE

1.CHECK DTC OUTPUT
a.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 459

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Telematics > Trouble Codes
50001 459

Result:
Result Proceed to
No DTCs are output. A
DTCs are output. B



A

B

2.INSPECT NAVIGATION ANTENNA ASSEMBLY
2.INSPECT NAVIGATION ANTENNA ASSEMBLY

b.
E356744C18
1.906,1.219 1.99,0.833 false 1.99,0.802 1.896,0.323 false 0.135,0.146 0.448,0.344 0.313,0.198 10 false *a 1.781,1.281 1.99,1.51 0.208,0.229 10 false 1a 1.771,0.135 1.979,0.365 0.208,0.229 10 false 1
*a Component without harness connected
(Navigation Antenna Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 1a Always 4 to 11 kΩ



Result:
Proceed to
OK
NG



OK

3.INSPECT ANTENNA CORD SUB-ASSEMBLY

NG

3.INSPECT ANTENNA CORD SUB-ASSEMBLY

b.
E334514C37
0.583,1 1,1.25 0.417,0.25 1.406,0.833 1.271,0.438 false 0.74,1.063 1.052,1.26 0.313,0.198 10 false D 1.083,0.24 1.396,0.438 0.313,0.198 10 false 1a 0.146,0.125 0.458,0.323 0.313,0.198 10 false *a
*a Component without harness connected
(Antenna Cord Sub-assembly)


E418545C01
1.552,0.167 1.969,0.417 0.417,0.25 2.302,1.833 1.969,1.417 false 1.719,0.229 1.875,0.427 0.156,0.198 10 false C 2.385,1.802 2.719,2 0.333,0.198 10 false 1a 0.167,0.146 0.365,0.323 0.198,0.177 10 false *a
*a Component without harness connected
(Antenna Cord Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
D-1 - C-1 Always Below 1 Ω
D-1a - C-1a Always Below 1 Ω
D-1 or C-1 - Body ground Always 10 kΩ or higher
D-1a or C-1a - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEMATICS TRANSCEIVER

NG