METER / GAUGE / DISPLAY METER / GAUGE SYSTEM Engine Oil Level Sensor Circuit
DESCRIPTION
The combination meter assembly and engine oil level sensor are connected via direct line. The combination meter assembly determines the engine oil level based on the engine oil level sensor signal.
- HINT:
-
As the engine oil level may be unstable when the engine is cold or running at high speeds, the combination meter assembly receives the engine coolant temperature signal and engine speed signal from the ECM via CAN communication in order to prevent the oil level warnings from being output erroneously.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
- NOTICE:
- for 7GR-FKS:
- ·
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
·The following troubleshooting procedure is based on the assumption that the SFI system is normal. Confirm that the SFI system is not malfunctioning before performing the following procedure.
- NOTICE:
- for 1GD-FTV:
- ·
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
·The following troubleshooting procedure is based on the assumption that the ECD system is normal. Confirm that the ECD system is not malfunctioning before performing the following procedure.
w/ DPF: Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>HOW TO PROCEED WITH TROUBLESHOOTING201902,999999,_51,_078856,_0385516,RM100000001H9CA,
w/ EGR Cooler: Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ EGR Cooler)>HOW TO PROCEED WITH TROUBLESHOOTING201902,999999,_51,_078856,_0388653,RM100000001HBNX,
w/o EGR Cooler: Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o EGR Cooler)>HOW TO PROCEED WITH TROUBLESHOOTING201902,999999,_51,_078856,_0388652,RM100000001HBSY,
for Water Cooled Type Intercooler: Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (for Water Cooled Type Intercooler)>HOW TO PROCEED WITH TROUBLESHOOTING202005,999999,_51,_078856,_0412266,RM100000001LNT5,
w/ Urea SCR System: Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>HOW TO PROCEED WITH TROUBLESHOOTING202208,999999,_51,_078856,_0382589,RM100000002569I,
w/ Exhaust Gas Temperature Sensor for EGR: Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR)>HOW TO PROCEED WITH TROUBLESHOOTING202208,999999,_51,_078856,_0395991,RM100000002570H,
PROCEDURE
Remove the engine oil level sensor.
for 7GR-FKS:
for 1GD-FTV:
Inspect the engine oil level sensor.
for 7GR-FKS:
for 1GD-FTV:
- Result:
Proceed to OK (for 7GR-FKS) OK (for 1GD-FTV) NG
OK (for 7GR-FKS)
OK (for 1GD-FTV)
NG
for 7GR-FKS:
for 1GD-FTV:
Disconnect the E96 engine oil level sensor connector.
Disconnect the N23 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition N23-31 (OILW) - E96-1 (LOIL) Always Below 1 Ω N23-31 (OILW) or E96-1 (LOIL) - Other terminals and body ground Always 10 kΩ or higher
- Result:
Proceed to OK NG
OK
NG
Disconnect the E97 engine oil level sensor connector.
Disconnect the N23 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition N23-31 (OILW) - E97-1 Always Below 1 Ω E97-2 - Body ground Always Below 1 Ω N23-31 (OILW) or E97-1 - Other terminals and body ground Always 10 kΩ or higher
- Result:
Proceed to OK NG
OK
NG