The side collision sensor RH circuit consists of the airbag sensor assembly and side airbag pressure sensor RH.
The side airbag pressure sensor RH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the SRS should be deployed.
These DTCs are stored when a malfunction is detected in the side airbag pressure sensor RH or airbag sensor assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Test Mode / Check Mode |
|---|---|---|---|---|---|
| B166C | Front Door Pressure Sensor RH | Either condition is met:
·
A side airbag pressure sensor RH malfunction. ·
An airbag sensor assembly malfunction. |
·
Side airbag pressure sensor RH ·
Airbag sensor assembly |
Comes on | Not applicable |
| B166F | Front Door Pressure Sensor Threshold Malfunction (RH) | Either condition is met:
·
A side airbag pressure sensor RH malfunction. ·
An airbag sensor assembly malfunction. |
·
Side airbag pressure sensor RH ·
Airbag sensor assembly |
Comes on | Not applicable |
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
When disconnecting and reconnecting the battery
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
After replacing the airbag sensor assembly, refer to initialization.
| *1 | Side Airbag Pressure Sensor LH |
| *2 | Airbag Sensor Assembly |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the side airbag pressure sensor RH with LH and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in memory.
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs.
| Proceed to |
|---|
| DTC B166C or B166F is output |
| DTC B167A or B167E is output |
| DTCs B166C, B166F, B167A and B167E are not output |
Codes other than DTCs B166C, B166F, B167A and B167E may be output at this time, but they are not related to this check.
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Return the side airbag pressure sensor LH and RH to their original positions and connect the connectors to them.
DTC B166C or B166F is output
DTC B167A or B167E is output
DTCs B166C, B166F, B167A and B167E are not output