Use the following procedure to troubleshoot the parking assist monitor system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.
The parking assist monitor display may be temporarily distorted due to radio waves around the vehicle.
| Problem Symptom | Cause |
|---|---|
| The problem symptom indicates a parking assist monitor display malfunction and the problem symptom cannot be reproduced. | The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver. |
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
w/ Audio and Visual System (for Radio and Display Type):
| Result | Proceed to |
|---|---|
| Navigation system and audio and visual system are normal | A |
| Navigation system is abnormal | B |
| Audio and visual system is abnormal | C |
A
B
C
Use the GTS to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
A
B
Check for DTCs and make a note of any codes that are output.
Clear the DTCs.
Recheck for DTCs. Try to reproduce the DTCs by duplicating the detection conditions of the DTCs.
C1622 is output from the radio and display receiver assembly. Therefore, if C1622 is output, proceed to the Problem Symptoms Table for the relevant systems.
w/ Navigation System:
w/ Audio and Visual System (for Radio and Display Type):
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTCs are output | B |
A
B
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT