This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.
If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.
If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.
Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and the radio and display receiver assembly itself will not function.
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.
Remove the steering pad switch assembly.
Inspect the steering pad switch assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the spiral cable sub-assembly.
Inspect the spiral cable sub-assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the O5 radio and display receiver assembly connector.
Disconnect the N58 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O5-21 (SW1) - N58-12 (AU1) | Always | Below 1 Ω |
| O5-22 (SW2) - N58-5 (AU2) | Always | Below 1 Ω |
| O5-24 (SWG) - N58-4 (EAU) | Always | Below 1 Ω |
| O5-21 (SW1) - Body ground | Always | 10 kΩ or higher |
| O5-22 (SW2) - Body ground | Always | 10 kΩ or higher |
| O5-24 (SWG) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG