The steering sensor receives the following switch information:
Light control switch in TAIL, HEAD, AUTO position
Dimmer switch in High, Low or Flash (pass) position
Fog light switch in Rr or OFF position
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Auto Light Switch | Light control switch AUTO position signal | OFF or ON | OFF: Light control switch not in AUTO position
ON: Light control switch in AUTO position |
- |
| Head Light Switch (Tail) | Light control switch TAIL position signal | OFF or ON | OFF: Light control switch in neither TAIL nor HEAD position
ON: Light control switch in TAIL or HEAD position |
- |
| Head Light Switch (Head) | Light control switch HEAD position signal | OFF or ON | OFF: Light control switch not in HEAD position
ON: Light control switch in HEAD position |
- |
| High Beam Main Switch | Dimmer switch high position signal | OFF or ON | OFF: Dimmer switch not in high position
ON: Dimmer switch in high position |
- |
| Passing Light Switch | Dimmer switch high flash position (pass) signal | OFF or ON | OFF: Dimmer switch not in high flash position
ON: Dimmer switch in high flash position |
- |
| Front Fog Light Switch | Front fog light switch signal | OFF or ON | OFF: Fog light switch in off position
ON: Fog light switch in Fr position |
- |
| Rear Fog Light/Bad Weather Switch | Rear fog light switch signal | OFF or ON | OFF: Fog light switch in off position
ON: Fog light switch in Fr&Rr position |
- |
| Tester Display |
|---|
| Auto Light Switch |
| Head Light Switch (Tail) |
| Head Light Switch (Head) |
| High Beam Main Switch |
| Passing Light Switch |
| Front Fog Light Switch |
| Rear Fog Light/Bad Weather Switch |
Normal conditions listed above are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Head Light Switch (Head) | Light control switch HEAD position signal | OFF or ON | OFF: Light control switch not in HEAD position
ON: Light control switch in HEAD position |
- |
| Tester Display |
|---|
| Head Light Switch (Head) |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Light Control Switch (HEAD) | Light control switch HEAD position signal | OFF or ON | OFF: Light control switch not in HEAD position
ON: Light control switch in HEAD position |
- |
| Tester Display |
|---|
| Light Control Switch (HEAD) |
Normal conditions listed above are displayed.
| Result | Proceed to |
|---|---|
| OK | A |
| NG ("Steering Angle Sensor" side abnormality) | B |
| NG ("Main Body" side abnormality) | C |
| NG ("Steering Angle Sensor" and "Main Body" are abnormality) | D |
A
B
C
D
Disconnect the G139 main body ECU (multiplex network body ECU) connector.
Disconnect the G68 steering sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G68-7 (HEAD) - G139-26 (HEAD) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G139 main body ECU (multiplex network body ECU) connector.
Disconnect the G68 steering sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G68-7 (HEAD) or G139-26 (HEAD) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| Proceed to |
|---|
| OK |
| NG |
OK
NG