This DTC is stored when the stereo component amplifier assembly detects an open in the rear speaker RH circuit by energizing the speaker line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1ACC71 | Rear Door Right Speaker Cable Actuator Stuck | Open in the rear speaker RH circuit is detected.
(1 trip detection logic) |
·
Harness or connector ·
Stereo component amplifier assembly ·
Rear Speaker Assembly RH |
Disconnect the K2 stereo component amplifier assembly connector.
Disconnect the H1 Rear speaker assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(K2,H1)Location & Routingewd_type=routing;type=c,c;code=K2,H1 Click Connector(K2)Body>Floor Wire>Stereo Component Amplifier Assemblyewd_type=component;type=c;code=K2;pinno=15,30 Click Connector(H1)Body>No. 1 Rear Door Wire / No. 2 Rear Door Wire>Rear Speaker Assembly RHewd_type=component;type=c;code=H1;pinno=2,1 |
||
| K2-15 (RR+) - H1-2 | Always | Below 1 Ω |
| K2-30 (RR-) - H1-1 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| Proceed to |
|---|
| OK |
| NG |
OK
NG