RM38N0EC _59 Vehicle Exterior _111837 MIRROR (EXT) _0510739 POWER MIRROR CONTROL SYSTEM(w/o Memory) J

MIRROR (EXT)  POWER MIRROR CONTROL SYSTEM(w/o Memory)  AUTO Power Retract Mirrors do not operate  


DESCRIPTION

The outer mirror switch assembly sends a mirror auto retract/return signal to the main body ECU (multiplex network body ECU) when the retractable outer mirror switch on the outer mirror switch assembly is in the auto retract position. The main body ECU (multiplex network body ECU) retracts or returns the outer rear view mirror assemblies based on the lock/unlock signal of each door while the ignition switch is off.

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.



PROCEDURE

1.CHECK POWER RETRACT MIRROR FUNCTION
a.

Check the power retract mirror function.

Click hereVehicle Exterior>MIRROR (EXT)>POWER MIRROR CONTROL SYSTEM (w/o Memory)>OPERATION CHECK

OK:

Power retract mirror function operates normally.



Result:
Proceed to
OK
NG



OK

2.CHECK POWER DOOR LOCK CONTROL SYSTEM

NG

2.CHECK POWER DOOR LOCK CONTROL SYSTEM
a.

Check the power door lock control system.

Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK

OK:

Power door lock control system is normal.



Result:
Proceed to
OK
NG



OK

3.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM

NG

3.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM
a.

Check the wireless door lock control system.


OK:

Wireless door lock control system is normal.



Result:
Proceed to
OK
NG



OK

4.CHECK SMART KEY SYSTEM (for Entry Function)

NG

5.READ VALUE USING GTS (OUTER MIRROR AUTO SWITCH)
a.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Outer Mirror Auto Switch Retractable outer mirror switch signal OFF or ON OFF: Retractable outer mirror switch not in auto retract position
ON: Retractable outer mirror switch in auto retract position
-
Body Electrical > Main Body > Data List
Tester Display
Outer Mirror Auto Switch
50003 449 72
OK:

On the GTS screen, ON or OFF is displayed accordingly.



Result:
Proceed to
OK
NG



OK

NG

6.INSPECT OUTER MIRROR SWITCH ASSEMBLY
6.INSPECT OUTER MIRROR SWITCH ASSEMBLY

OK

7.CHECK HARNESS AND CONNECTOR (OUTER MIRROR SWITCH ASSEMBLY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))

NG

7.CHECK HARNESS AND CONNECTOR (OUTER MIRROR SWITCH ASSEMBLY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
a.

Disconnect the E36 main body ECU (multiplex network body ECU).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(I8,E36)Location & Routing

Click Connector(I8)Body>No. 2 Front Door Wire RH / No. 2 Front Door Wire LH>Outer Mirror Switch Assembly

Click Connector(E36)Instrument Panel>Instrument Panel Wire / Radio Wiring Sub-Assy / Telephone Computer Wire>Multiplex Network Body ECU

I8-9 (MAT) - E36-26 (AMR) Always Below 1 Ω
I8-9 (MAT) or E36-26 (AMR) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR