The rear corner ultrasonic sensor LH is installed on the rear bumper. The clearance warning ECU assembly detects obstacles based on signals it receives from the rear corner ultrasonic sensor LH. If an open circuit or other malfunction occurs in the rear corner ultrasonic sensor LH, the rear corner ultrasonic sensor LH does not operate correctly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C1AE696 | Ultrasonic Sensor (Rear Left Corner) Component Internal Failure | Rear corner ultrasonic sensor LH malfunction | ·
Rear corner ultrasonic sensor LH ·
Clearance warning ECU assembly |
Clearance Warning | B |
Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
If a DTC is detected again after the repair, turn the ignition switch to ON and turn the toyota parking assist-sensor system on, and then clear the DTC.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| C1AE696 and C1AE687 are output | B |
| C1AE696 is output | C |
A
B
C
Replace the rear corner ultrasonic sensor LH with a new or normally functioning one.
To check if the ultrasonic sensor is functioning correctly, replace it with another ultrasonic sensor.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| C1AE696 is output | B |
A
B