RM36D0EC _55 Steering _083084 STEERING COLUMN _0402690 STEERING COLUMN ASSEMBLY A

STEERING COLUMN STEERING COLUMN ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during steering column assembly removal/installation are shown below.

HINT:

for HV Model:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
Lane tracing assist system	Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more.	(201910,999999,_58,_083101,_0401880,RM100000001JE9I,)
Pre-collision system		(201910,999999,_58,_083101,_0401880,RM100000001JE9I,)

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
Power back door function	Fully close the back door by hand. HINT: Initialization is not necessary if the above procedures are performed while the back door is closed.	(202304,999999,_59,_083093,_0584672,RM1000000029PGT,)
Power door lock control system	If the back door is locked and therefore cannot be opened, it is necessary to unlock the back door using the door control switch, electrical key transmitter sub-assembly switch.	(202409,999999,_58,_083092,_0403003,RM100000002NS90,)
Air conditioning system	After the ignition switch is turned to ON, the servo motor standard position is recognized	-

HINT:

for Gasoline Model:

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
Stop and start system	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes).	(202409,999999,_51,_083056,_0402418,RM100000002NSFO,)
Lane tracing assist system	Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more.	(201910,999999,_58,_083101,_0401880,RM100000001JE9I,)
Pre-collision system		(201910,999999,_58,_083101,_0401880,RM100000001JE9I,)

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
*: w/ Power back door system
Power back door function*	Fully close the back door by hand. HINT: Initialization is not necessary if the above procedures are performed while the back door is closed.	(202304,999999,_59,_083093,_0584672,RM1000000029PGT,)
Power door lock control system	If the back door is locked and therefore cannot be opened, it is necessary to unlock the back door using the door control switch, electrical key transmitter sub-assembly switch.	(202409,999999,_58,_083092,_0403003,RM100000002NS90,)
Air conditioning system	After the ignition switch is turned to ON, the servo motor standard position is recognized	-

PROCEDURE

Hide Display 1. PRECAUTION

CAUTION:: Be sure to read precaution thoroughly before servicing.; ·

for GTMC Made:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for GTMC Made)>PRECAUTION202405,999999,_58,_083100,_0694959,RM100000002LV12,

·

for SFTM Made:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for SFTM Made)>PRECAUTION202409,999999,_58,_083100,_0694957,RM100000002NSNT,

NOTICE:: After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.; Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY202304,999999,_V1,_083041,_0402304,RM100000002AYZV,

Hide Display 2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide Display 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

for M20C-FKS:

Click hereGeneral>MAINTENANCE>M20C-FKS BATTERY>REMOVAL202409,999999,_V1,_083136,_0418197,RM100000002NHPI,

for M20D-FKS:

Click hereGeneral>MAINTENANCE>A25D-FXS AUXILIARY BATTERY>REMOVAL202409,999999,_V1,_083136,_0477834,RM100000002NHPM,

for A25B-FXS:

Click hereGeneral>MAINTENANCE>A25B-FXS AUXILIARY BATTERY>REMOVAL202409,999999,_V1,_083136,_0403618,RM100000002NHPL,

for A25D-FXS:

Click hereGeneral>MAINTENANCE>M20D-FKS BATTERY>REMOVAL202409,999999,_V1,_083136,_0403617,RM100000002NHPJ,

for A25F-FXS:

Click hereGeneral>MAINTENANCE>A25F-FXS AUXILIARY BATTERY (Production date from 2021/08)>REMOVAL202409,999999,_V1,_083136,_0486275,RM100000002NHPN,

CAUTION:: ·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.

Hide Display 67914B 4.REMOVE FRONT DOOR SCUFF PLATE LH

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL202304,999999,_58,_083106,_0400609,RM1000000029RST_01_0069,

Hide Display 62112 5.REMOVE COWL SIDE TRIM BOARD LH

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL202409,999999,_58,_083106,_0400607,RM100000002NG5W_01_0028,

Hide Display 55606 6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL202409,999999,_58,_083106,_0400607,RM100000002NG5W_01_0002,

Hide Display 55474B 7.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL202409,999999,_58,_083106,_0400607,RM100000002NG5W_01_0003,

Hide Display 55545 8.REMOVE FUSE BOX OPENING COVER

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL202409,999999,_58,_083106,_0400607,RM100000002NG5W_01_0009,

Hide Display 55480D 9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL202409,999999,_58,_083106,_0400607,RM100000002NG5W_01_0011,

Hide Display 73900 10.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>KNEE AIRBAG ASSEMBLY>REMOVAL202409,999999,_58,_083100,_0400495,RM100000002NG0B,

Hide Display 45100 11.REMOVE STEERING WHEEL ASSEMBLY

Click hereSteering>STEERING COLUMN>STEERING WHEEL>REMOVAL202409,999999,_55,_083084,_0402691,RM100000002NT5V,

Hide Display 55410C 12.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL202409,999999,_58,_083106,_0400607,RM100000002NG5W_01_0004,

Hide Display 45287 13.REMOVE LOWER STEERING COLUMN COVER

Remove the 3 screws.

0,0 0,0 false

	Place Hands Here
	Remove in this Direction

While pressing the push area shown in the illustration to detach the 2 claws, slightly lower the lower steering column cover

Hide Display 45286B 14.REMOVE UPPER STEERING COLUMN COVER

0,0 0,0 false

Remove in this Direction

Detach the claw and separate the upper steering column cover.

Detach the 2 claws and 4 clips to remove the upper steering column cover.

Hide Display 89782 15.REMOVE TRANSPONDER KEY COIL (w/o Entry and Start System)

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>TRANSPONDER KEY AMPLIFIER>REMOVAL201910,999999,_58,_083094,_0400684,RM100000001J9CQ_01_0003,

Hide Display 16.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

NOTICE:: ·

Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the ignition switch ON.

·

Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

Disconnect each connector from the turn signal switch assembly with spiral cable sub-assembly.

Using pliers, support the band clamp while loosened.

Detach the claw to remove the turn signal switch assembly with spiral cable sub-assembly from the steering column assembly.

Hide Display 87201B 17.REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY

1.729,0.198 1.99,0.406 0.26,0.208 10 false *a

*a	View A
	Front

Remove the 2 bolts.

Detach the 3 claws to remove the No. 2 air duct sub-assembly.

NOTICE:: Be careful not to deform or damage the lower heater case of the air conditioner unit assembly when removing the No. 2 air duct sub-assembly.

Hide Display 18.REMOVE FRONT WHEEL LH

Click hereGeneral>MAINTENANCE>TIRE AND WHEEL>REMOVAL202409,999999,_V1,_083136,_0403660,RM100000002NOW9,

Hide Display 45220 19.DISCONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

Click hereSteering>STEERING GEAR / LINKAGE>STEERING GEAR>REMOVAL202409,999999,_55,_083085,_0402713,RM100000002NT5R_01_0131,

Hide Display 45253 20.REMOVE STEERING COLUMN HOLE COVER

Turn back the floor carpet.

Remove the clip.

Detach the 2 clips to remove the steering column hole cover.

Hide Display 45220 21.REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY

Using a screwdriver, loosen the clamp as shown in the illustration.

1.625,0.594 0.885,0.333 0.885,0.333 1.625,0.51 true 0.552,0.24 0.854,0.448 0.302,0.208 10 true *a

Matchmark

Remove the bolt and slide the steering intermediate shaft assembly.

NOTICE:: Do not remove the steering intermediate shaft assembly from the steering column assembly.

Put matchmarks on the steering intermediate shaft assembly and steering column assembly.

Remove the steering intermediate shaft assembly from the steering column assembly.

Hide Display 45250 22.REMOVE STEERING COLUMN ASSEMBLY

Disconnect each connector and disengage each wire harness clamp from the steering column assembly.

Remove the bolt, 2 nuts and steering column assembly.