DOOR / HATCH  POWER BACK DOOR SYSTEM  INITIALIZATION  

INITIALIZE MULTIPLEX NETWORK DOOR ECU

NOTICE:

Initialization of the multiplex network door ECU (back door initial position learning) is necessary if the following work procedures are performed while the back door is open.

·

The cable to the negative (-) auxiliary battery terminal is connected.

·

A power source system fuse of the power back door system is disconnected and reconnected.

·

The multiplex network door ECU is replaced or the connectors are disconnected.

·

The power back door unit assembly set LH/RH is removed and installed or replaced.

The power back door does not operate unless the multiplex network door ECU is initialized.

HINT:

·

Initialization is not necessary if the above procedures are performed while the back door is closed.

·

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART202304,202405,_V1,_083041,_0402304,RM100000002AJ9H,202405,202409,_V1,_083041,_0402304,RM100000002LTUF,202409,999999,_V1,_083041,_0402304,RM100000002NY03,