WINDOW / GLASS POWER WINDOW CONTROL SYSTEM Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH
DESCRIPTION
If the manual up and down function operates normally but the auto up and down function does not, then fail-safe mode may be functioning.
If power window initialization has not been performed, the auto up and down function will not operate.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
- NOTICE:
- ·
If the rear power window regulator motor assembly LH has been replaced with a new one, initialize the power window control system.
·Check that the "RL Window Auto Up" and "RL Window Auto Down" power window control system customize settings are "ON" before proceeding with work.
·After the catch protection function operates, the auto operation is not performed the first time auto up is performed. All auto up operations performed after the first operate normally.
- HINT:
-
If the pulse sensor built into the rear power window regulator motor assembly LH is malfunctioning, the power window control system enters fail-safe mode. The remote up and down and auto up and down functions cannot be operated during fail-safe mode. However, the power window can be closed by holding the rear power window regulator switch assembly LH at the auto up position, and opened manually by pushing down the rear power window regulator switch assembly LH.
PROCEDURE
Using the GTS, read the data for the condition when the rear power window regulator switch assembly LH was operated.
- Body Electrical > RL-Door Motor > Data List
-
Tester Display Measurement Item Range Normal Condition Diagnostic Note RL Door P/W Auto SW Rear LH door power window auto switch signal OFF or ON OFF: Rear LH door power window auto switch not being operated
ON: Rear LH door power window auto switch being operated-
- Body Electrical > RL-Door Motor > Data List
-
Tester Display RL Door P/W Auto SW - 50003 146 1
- OK:
On the GTS screen, ON or OFF is displayed accordingly.
- Result:
Proceed to OK NG
OK
NG
Initialize the rear power window regulator motor assembly LH.
- OK:
Power window system operates normally.
- Result:
Proceed to OK NG
OK
NG
Remove the rear power window regulator switch assembly LH.
Inspect the rear power window regulator switch assembly LH.
- Result:
Proceed to OK NG
OK
NG
Disconnect the L2 rear power window regulator switch assembly LH connector.
Disconnect the L5 rear power window regulator motor assembly LH connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition L2-8 (AUTO) - L5-4 (AUTO) Always Below 1 Ω L2-8 (AUTO) or L5-4 (AUTO) - Body ground Always 10 kΩ or higher
- Result:
Proceed to OK NG
OK
NG