1.INSPECT BRAKE FLUID LEVEL IN RESERVOIR
44610
2.INSPECT BRAKE BOOSTER ASSEMBLY
3.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55737B
4.REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (w/ No. 1 Heater Air Duct Splash Shield Seal)
55701J
5.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
83390H
6.INSPECT VACUUM WARNING SWITCH ASSEMBLY
Start the engine and stop it after 1 or 2 minutes.
Disconnect the connector from the vacuum warning switch assembly.
Measure the resistance of the vacuum warning switch assembly.
10 kΩ or higher
With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly.
Below 1 Ω
Connect the connector to the vacuum warning switch assembly.
55701J
7.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
55737B
8.INSTALL NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (w/ No. 1 Heater Air Duct Splash Shield Seal)
9.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY