Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the lumbar support adjuster assembly removal/installation are shown below.
| Replacement Part or Procedure | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) battery terminal | Memorize steering angle neutral point | Parking assist monitor system | ( 201902,999999,_56,_079315,_0385736,RM100000001GNRA,)
|
| Panoramic view monitor system | ( 201906,999999,_56,_079315,_0396274,RM100000001IGR3,)
|
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
| Effect/Inoperative Function When Necessary Procedures not Performed | Necessary Procedures | Link |
|---|---|---|
| Stop and start system | Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). | ( 201902,999999,_51,_078825,_0382334,RM100000001GBQ1,)
|
| Lane control system | Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. | ( 201902,999999,_58,_078886,_0382740,RM100000001G6XB,)
|
| Pre-collision system |
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures not Performed | Necessary Procedures | Link |
|---|---|---|
| Power slide door system | Fully close the slide door by hand.
|
( 201902,999999,_59,_078503,_0381017,RM100000001FWXM,)
|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor standard position is recognized. | - |
1.REMOVE FRONT SEAT ASSEMBLY RH
Use the same procedure described for the LH side.
71861K
2.REMOVE FRONT SEAT INNER CUSHION SHIELD RH
Use the same procedure described for the LH side.
71811T
3.REMOVE FRONT SEAT CUSHION SHIELD RH
Use the same procedure described for the LH side.
71705F
4.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
5.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Use the same procedure described for the LH side.
6.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Use the same procedure described for the LH side.
72750G
7.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY RH
Disconnect the connector and detach the clamp.
| *a | Clamp | *b | Guide |
|
Remove in this Direction | - | - |
Detach the claw.
Detach the guide and remove the lumbar support adjuster assembly RH.
71587K
8.REMOVE FRONT SEATBACK EDGE PROTECTOR RH
Use the same procedure described for the LH side.
71759E
9.REMOVE FRONT SEATBACK HOOK RH
Use the same procedure described for the LH side.