THEFT DETERRENT / KEYLESS ENTRY THEFT DETERRENT SYSTEM Engine Hood Courtesy Switch Circuit

DESCRIPTION

The engine hood courtesy switch is installed together with the hood lock. This switch turns on when the engine hood is closed and turns off when the engine hood is opened.

WIRING DIAGRAM

5.427,2.063 7.094,2.438 1.667,0.375 10 false Main Body ECU (Multiplex Network Body ECU) 0.823,1.542 2.729,1.927 1.906,0.385 10 false Hood Lock Assembly (Engine Hood Courtesy Switch) 5.844,1.01 6.281,1.24 0.438,0.229 10 false HCTY 5.583,1.021 6.021,1.25 0.438,0.229 10 false 30 2.021,1.01 2.458,1.24 0.438,0.229 10 false 1 0.969,1.01 1.406,1.24 0.438,0.229 10 false 2 5.427,1.896 5.865,2.125 0.438,0.229 10 false N19 0.833,1.396 1.271,1.625 0.438,0.229 10 false A11 6.26,0.698 6.698,0.927 0.438,0.229 10 false +B

CAUTION / NOTICE / HINT

NOTICE:: w/ Entry and Start System:; If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.

PROCEDURE

1.READ VALUE USING GTS (HOOD COURTESY SW)

a.

Connect the GTS to the DLC3.

b.

Turn the ignition switch to ON.

c.

Turn the GTS on.

d.

Enter the following menus: Body Electrical / Main Body / Data List.

e.

According to the display on the GTS, read the Data List.

Body Electrical > Main Body > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
Hood Courtesy SW	Engine hood courtesy switch	ON or OFF	ON: Engine hood open OFF: Engine hood closed	-

Body Electrical > Main Body > Data List

Tester Display
Hood Courtesy SW

50003 123 200

OK:: The indicator on the GTS switches between ON and OFF in accordance with the hood lock assembly (engine hood courtesy switch) status.

Result:

Proceed to
OK
NG

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>PROBLEM SYMPTOMS TABLE201906,999999,_58,_078378,_0388156,RM100000001IOTH,

NG

2.CHECK HARNESS AND CONNECTOR (HOOD LOCK ASSEMBLY [ENGINE HOOD COURTESY SWITCH] - MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] AND BODY GROUND)

a.

Disconnect the A11 hood lock assembly (engine hood courtesy switch) connector.

b.

Disconnect the N19 main body ECU (multiplex network body ECU) connector.

c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
A11-1 - N19-30 (HCTY)	Always	Below 1 Ω
A11-2 - Body ground	Always	Below 1 Ω
A11-1 or N19-30 (HCTY) - Other terminals and body ground	Always	10 kΩ or higher