WINDOW / GLASS POWER WINDOW REGULATOR MOTOR INSTALLATION
CAUTION / NOTICE / HINT
- HINT:
- ·
Use the same procedure for the RH and LH sides.
·The procedure listed below is for the LH side.
PROCEDURE
85720C
1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH to the front door window regulator sub-assembly LH with the 3 "TORX" screws.
- Torque:
- 5.4 N*m (55 kgf*cm, 48 in.*lbf)
- HINT:
-
A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
69820
2.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY LH
67834
3.INSTALL FRONT DOOR NO. 2 SERVICE HOLE COVER LH
68151D
4.CONNECT FRONT DOOR GLASS RUN LH
68102
5.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
67402F
6.INSTALL FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH
68151D
7.INSTALL FRONT DOOR GLASS RUN LH
67838F
8.INSTALL FRONT DOOR NO. 4 SERVICE HOLE COVER LH (w/ Curtain Shield Airbag)
67832
9.INSTALL FRONT DOOR SERVICE HOLE COVER LH
67626A
10.INSTALL NO. 2 DOOR TRIM BRACKET
86160
11.INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
68193C
12.INSTALL FRONT DOOR FRONT BELT SEAL LH
68195B
13.INSTALL FRONT DOOR REAR BELT SEAL LH
68172A
14.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH
67602
15.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
16.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
17.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
69278B
18.INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH
19.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
20. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
- HINT:
-
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is usel.
21. INITIALIZE POWER WINDOW CONTROL SYSTEM
22. CHECK POWER WINDOW CONTROL SYSTEM
23. CHECK POWER DOOR LOCK CONTROL SYSTEM