TIRE PRESSURE MONITORING TIRE PRESSURE WARNING SYSTEM TEST MODE PROCEDURE
TEST MODE (SIGNAL CHECK MODE) PROCEDURE
- HINT:
- ·
When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal check mode) DTCs first.
After the tire pressure warning ECU and receiver completes the signal check for each inspection item, the DTCs for systems that are determined to be normal will be cleared.
The DTCs for other inspection items may not be cleared when only a certain signal is inspected.
·When test mode (signal check mode) returns to normal mode, all the test mode (signal check mode) DTCs will be cleared.
·During test mode (signal check mode), the system is not initialized even if the initialization procedure is performed.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and the GTS on.
| *a | 0.125 sec. |
| *b | ON |
| *c | OFF |
Enter the following menus: Chassis / Tire Pressure Monitor / Utility / Signal Check.
- Chassis > Tire Pressure Monitor > Utility
-
Tester Display Signal Check - 50005 203 3
- HINT:
-
Every time the test mode (signal check mode) DTC clear conditions are satisfied, the tire pressure warning light illuminates for 1 second. Following this, the tire pressure warning light blinks at 0.125 second intervals.
Tire pressure warning reset switch check (DTC C2198).
Wait for 1.5 minutes with the vehicle stopped, or drive the vehicle at a speed of 50 km/h (31 mph) or more for 1 minute (DTCs C2181 to C2185).
- HINT:
-
The tire pressure warning valve and transmitters send signals to the tire pressure warning ECU and receiver once every 1.5 minutes while the vehicle is stopped and once every minute while driving.
Check that the tire pressure warning system test mode (signal check mode) DTCs are cleared.
| Test Mode (Signal Check Mode) DTC | Test Signal | Test Mode (Signal Check Mode) DTC Clear Condition |
|---|---|---|
| C2181 to C2185 | Transmitter Data | Data is received from the relevant transmitter which has a registered ID in the tire pressure warning ECU and receiver. |
| C2198 | Tire Pressure Warning Reset Switch Signal | A signal is received indicating that the tire pressure warning reset switch is pressed. |
Result
- HINT:
-
After the signal check is completed, check for test mode (signal check mode) DTCs to confirm the system status.
| Condition | Procedure |
|---|---|
| Test mode (signal check mode) DTCs are output | Repair the faulty part and enter Signal Check again |
| Test mode (signal check mode) DTCs are cleared | No problem |
End of test mode (signal check mode)
After completing test mode (signal check mode), turn the ignition switch off and disconnect the GTS.
Test mode (signal check mode) DTCs
If a trouble code is displayed during the test mode (signal check mode) DTC check, check the diagnosis procedure listed for that code. For details of each code, refer to Link below.
