7GR-FKS STARTING STARTER INSTALLATION
PROCEDURE
11363A
1.INSTALL FLYWHEEL HOUSING SIDE COVER
Install the flywheel housing side cover to the cylinder block sub-assembly.
28100
2.INSTALL STARTER ASSEMBLY
Install the starter assembly with the 2 bolts.
- Torque:
- 37 N*m (377 kgf*cm, 27 ft.*lbf)
Connect the engine wire with the bolt and nut.
- Torque:
- Bolt : 13 N*m (133 kgf*cm, 10 ft.*lbf)
- Nut : 9.8 N*m (100 kgf*cm, 87 in.*lbf)
Close the terminal cap.
Connect the starter assembly connector.
Connect the ground wire with the bolt.
- Torque:
- 19 N*m (194 kgf*cm, 14 ft.*lbf)
28192
3.INSTALL STARTER COVER
Install the starter cover with the 3 bolts.
- Torque:
- 11.5 N*m (117 kgf*cm, 8 ft.*lbf)
17150
4.INSTALL EXHAUST MANIFOLD ASSEMBLY LH
51407A
5.INSTALL NO. 3 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 3 Engine Under Cover Sub-assembly)
51405A
6.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
52618
7.INSTALL LOWER FRONT BUMPER ABSORBER
51406A
8.INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
- HINT:
-
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.