When replacing the radio and display receiver assembly, always replace it with a new one.
If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio and display receiver assembly may not operate normally.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Make sure that the disc is an audio disc or a disc with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
Disc is normal.
Translucent or uniquely-shaped CDs cannot be played.
CDs with adhesive paper labels should not be played.
Commercial audio CDs can be played.
CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
For details on playable CDs, refer to Owner's Manual.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check if the disc is inserted upside down.
Disc is properly inserted.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disc cleaning
If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.
Malfunction disappears.
Do not use a conventional record cleaner or antistatic preservative.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the disc with a known good one and check that the malfunction disappears.
Malfunction disappears.
| Proceed to |
|---|
| OK |
| NG |
OK
NG