The No. 1 cooler thermistor is installed to the evaporator in the air conditioner unit to detect the temperature of the cooled air that has passed through the evaporator, which is used to control the air conditioning system. It sends signals to the air conditioning amplifier assembly. The resistance of the No. 1 cooler thermistor changes in accordance with the temperature of the cooled air that has passed through the evaporator. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.
The air conditioning amplifier assembly applies voltage to the No. 1 cooler thermistor and reads voltage changes as the resistance of the No. 1 cooler thermistor changes.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| P053511 | Evaporator Temperature Sensor Circuit Short to Ground | Diagnosis Condition:
Ignition switch ON Malfunction Status: Short in evaporator temperature sensor circuit Detection Time: Continuously for 4 seconds or more |
·
No. 1 cooler thermistor ·
Air conditioning harness assembly ·
Air conditioning amplifier assembly |
Memorized |
Check vehicle specifications.
| Result | Proceed to |
|---|---|
| w/ Rear Air Duct | A |
| w/o Rear Air Duct | B |
A
B
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
| *1 | No. 1 Cooler Thermistor |
| *2 | Air Conditioning Amplifier Assembly |
Disconnect the A No. 1 cooler thermistor connector.
Turn the ignition switch to ON and wait for 4 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| P053515 is output | A |
| P053511 is output | B |
A
B
Remove the air conditioning harness assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| z1-5 (SGA) or A-1 - Other terminals and body ground | Always | 10 kΩ or higher |
| z1-6 (TEA) or A-2 - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
| *1 | No. 1 Cooler Thermistor |
| *2 | Air Conditioning Amplifier Assembly |
Disconnect the m2 No. 1 cooler thermistor connector.
Turn the ignition switch to ON and wait for 4 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| P053515 is output | A |
| P053511 is output | B |
A
B
Remove the air conditioning harness assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| m6-5 (SG-3) or m2-1 - Other terminals and body ground | Always | 10 kΩ or higher |
| m6-6 (TE) or m2-2 - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG