RM36D0EC _51 Engine / Hybrid System _083055 CRUISE CONTROL _0403826 LANE TRACING ASSIST SYSTEM T

CRUISE CONTROL  LANE TRACING ASSIST SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.

·

When the forward recognition camera is replaced or removed/installed, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history (RoB) for each system.

HINT:

Perform forward recognition camera optical axis alignment with either "One time recognition" or "Sequential recognition". Refer to the following for clearing the vehicle control history.

One time recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)

Sequential recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)

Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>DRIVING ADJUSTMENT


·

When the forward recognition camera is replaced, update the ECU security key.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>UPDATE ECU SECURITY KEY

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in the combination meter assembly will not match the information from the vehicle, and may cause a DTC to be output.

·

When the combination meter assembly is replaced, update the ECU security key.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>UPDATE ECU SECURITY KEY



HINT:
·

If no problem symptoms are found when a DTC is output in the DTC check on the lane tracing assist system, check each symptom by checking the suspected areas in the order they are listed.

·

Before performing failure diagnosis according to the following inspection points, check the forward recognition camera system power source circuit fuses and relays.



LANE TRACING ASSIST SYSTEM
Symptom Suspected Area Link
Lane tracing assist system does not operate at all Steering pad switch circuit Click here
Forward recognition camera adjustment
HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.



The LTA indicator light does not turn off even by operating the LTA main switch (steering pad switch assembly) Indicator circuit Click here
Steering pad switch circuit Click here
Combination meter assembly Click here
The lane tracing assist system is not canceled even by operating the turn signals Data list / Active test (Check the item "Turn Switch (Right)", "Turn Switch (Left)") Click here
Turn signal switch circuit Click here
The lane tracing assist system does not operate many times even when the white lines are visible Check conditions for operating/not operating Click here
Forward recognition camera adjustment
HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.



The lane tracing assist system is operating but the system control status is not displayed on the multi-information display Data list / Active test (Check the item "LDA Control") Click here
Combination meter assembly Click here
Lane departure warning function is on but the buzzer does not sound even when straying from white line Combination meter assembly Click here