When the ignition switch is ON, the front power window regulator motor assembly RH is operated by the power window regulator switch assembly. The front power window regulator motor assembly RH has motor, regulator and ECU functions.
The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
If the power window regulator motor assembly RH has been replaced with a new one, initialize the power window control system.
Check that the window lock switch is off before performing the following procedure.
Inspect the fuse for circuits related to this system before performing the following procedure.
Using the GTS, read the data for the condition when the power window regulator switch assembly was operated.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| P Door P/W Up SW | Front passenger door power window manual up switch signal | OFF or ON | OFF: Front passenger door power window manual up switch not being operated
ON: Front passenger door power window manual up switch being operated |
- |
| P Door P/W Down SW | Front passenger door power window manual down switch signal | OFF or ON | OFF: Front passenger door power window manual down switch not being operated
ON: Front passenger door power window manual down switch being operated |
- |
| Tester Display |
|---|
| P Door P/W Up SW |
| P Door P/W Down SW |
On the GTS screen, ON or OFF is displayed accordingly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the power window regulator switch assembly.
Inspect the power window regulator switch assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the I3 power window regulator switch assembly connector.
Disconnect the I7 front power window regulator motor assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I3-5 (UP) - I7-10 (UP) | Always | Below 1 Ω |
| I3-4 (DOWN) - I7-7 (DOWN) | Always | Below 1 Ω |
| I3-8 (AUTO) - I7-4 (AUTO) | Always | Below 1 Ω |
| I3-5 (UP) or I7-10 (UP) - Body ground | Always | 10 kΩ or higher |
| I3-4 (DOWN) or I7-7 (DOWN) - Body ground | Always | 10 kΩ or higher |
| I3-8 (AUTO) or I7-4 (AUTO) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG