This DTC is stored when LIN communication between the sliding roof ECU (sliding roof drive gear assembly [sliding roof]) and roof sunshade ECU (sliding roof drive gear assembly [roof sunshade]) stops for 10 seconds or more.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2346 | Lost Communication with Front Shade Module | No communication between the sliding roof ECU (sliding roof drive gear assembly [sliding roof]) and roof sunshade ECU (sliding roof drive gear assembly [roof sunshade]) for 10 seconds or more. | ·
Sliding roof ECU (sliding roof drive gear assembly [sliding roof]) ·
Roof sunshade ECU (sliding roof drive gear assembly [roof sunshade]) ·
Harness or connector |
Inspect the fuse for circuits related to this system before performing the following inspection procedure.
When the sliding roof ECU (sliding roof drive gear assembly [sliding roof]) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear assembly [sliding roof]) must be initialized.
When the roof sunshade ECU (sliding roof drive gear assembly [roof sunshade]) is removed and reinstalled or replaced, the roof sunshade ECU (sliding roof drive gear assembly [roof sunshade]) must be initialized.
Clear the DTCs.
Check for DTCs.
DTC B2346 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the P4 sliding roof ECU (sliding roof drive gear assembly [sliding roof]) connector.
Disconnect the A roof sunshade ECU (sliding roof drive gear assembly [roof sunshade]) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P4-3 (MPX2) - A-3 (LLIN) | Always | Below 1 Ω |
| P4-3 (MPX2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Roof Sunshade ECU [Sliding Roof Drive Gear Assembly (Roof Sunshade)]) |
Disconnect the roof sunshade ECU (sliding roof drive gear assembly [roof sunshade]) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-2 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-1 (+B) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the roof sunshade ECU (sliding roof drive gear assembly [roof sunshade]) with a new or normally functioning one.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
DTC B2346 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG