THEFT DETERRENT / KEYLESS ENTRY DIGITAL KEY RECEIVER(for Front Floor) REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ble indoor digital key receiver assembly removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Reset back door close position | Power Back Door System | ( 202111,999999,_59,_111831,_0505274,RM100000001ZMEG,)
|
| BLE indoor digital key receiver assembly | Code registration | ·
Wireless Door Lock Control System ·
Smart Entry and Start System (for Entry function, HV Model) ·
Smart Entry and Start System (for Start function, HV Model) ·
Hybrid control system cannot be started ·
Digital Key System |
See Service Bulletin for the registration method |
- NOTICE:
-
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
- HINT:
-
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Lane Tracing Assist System Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. ( 202111,999999,_95,_111850,_0502173,RM100000001Z92I,)
Pre-collision System
Learning completes when vehicle is operated normally Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Power Door Lock Control System
·Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. ( 202111,999999,_58,_111830,_0505351,RM100000001ZMT3,)
Air Conditioning System After the ignition switch is turned to ON, the servo motor standard position is recognized. -
PROCEDURE
62311B
1.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
55317E
2.REMOVE NO. 1 INSTRUMENT SIDE PANEL
55475A
3.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
58834B
4.REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH
58833B
5.REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH
58835C
6.REMOVE CONSOLE BOX ORNAMENT (w/o Seat Heater System)
58835C
7.REMOVE CONSOLE BOX ORNAMENT (w/ Seat Heater System)
33504F
8.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
for K120:
for P710:
58804A
9.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
58803C
10.REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY
890G0
11.REMOVE BLE INDOOR DIGITAL KEY RECEIVER ASSEMBLY
Disconnect the connector.
Disengage the clamp to remove the ble indoor digital key receiver assembly.
- NOTICE:
-
Be careful when removing the digital key receiver. If the ble indoor digital key receiver assembly is dropped,replace it with a new one.