DOOR / HATCH  POWER BACK DOOR SYSTEM  INITIALIZATION  

INITIALIZE MULTIPLEX NETWORK DOOR ECU

NOTICE:

Initialization of the multiplex network door ECU (back door initial position learning) is necessary if any of the following have been performed with the back door open.

·

The cable is disconnected from the negative (-) auxiliary battery terminal.

·

A fuse of the power back door system power source circuit has been removed and installed or replaced.

·

The multiplex network door ECU is removed and installed or replaced, or a connector is disconnected.

·

The power back door unit assembly set LH/RH is removed and installed or replaced.

The power back door system will not operate unless the multiplex network door ECU has been initialized.

HINT:

·

Initialization is not necessary if the above have been performed with the back door closed.

·

When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the negative (-) auxiliary battery terminal is reconnected.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE202111,202203,_V1,_111780,_0504976,RM100000001ZKRT,202203,202406,_V1,_111780,_0504976,RM1000000022CKY,202406,999999,_V1,_111780,_0504976,RM100000002MNUE,