RM38N0EC _58 Vehicle Interior _111830 DOOR LOCK _0501510 DOOR CONTROL RECEIVER A

DOOR LOCK  DOOR CONTROL RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during electrical key and tire pressure warning ECU and receiver removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
·

Tire pressure warning ECU and receiver (Electrical key and TPMS receiver assembly)

·

Tire pressure warning valve and transmitter


·

ID Registration

·

Initialization

·

Tire Position Identification


Tire Pressure Warning System Refer to Procedures Necessary When Replacing Parts (for Tire Pressure Warning System) table below
(Click here)

NOTICE:

When replacing the electrical key and tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST


PROCEDURE

Hide 62331C 14.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

a.

Disconnect the rear door opening trim weatherstrip LH.


Hide 73705 18.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH

Hide 897B0A 23.REMOVE ELECTRICAL KEY AND TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop, strike or otherwise subject the electrical key and tire pressure warning ECU and receiver to impact.

·

If the electrical key and tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
B628811

Remove the 2 bolts.


b.

Disengage the 2 guides.


c.

Disconnect the connector to remove the electrical key and tire pressure warning ECU and receiver.