The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning ECU and receiver removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Tire pressure warning ECU and receiver | ·
ID Registration ·
Initialization ·
Tire Position Identification |
Tire Pressure Warning System | Refer to Procedures Necessary When Replacing Parts (for Tire Pressure Warning System)
( 202203,202303,_V1,_111780,_0504977,RM1000000022CKZ,202303,202406,_V1,_111780,_0504977,RM100000002AA1Y,202406,202409,_V1,_111780,_0504977,RM100000002MO96,202409,999999,_V1,_111780,_0504977,RM100000002OMBP,)
|
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
58410B
1.REMOVE DECK BOARD ASSEMBLY
71940A
2.REMOVE REAR SEAT HEADREST ASSEMBLY (for RH Side)
71960B
3.REMOVE REAR SEAT CENTER HEADREST ASSEMBLY
4.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
5.REMOVE REAR SEAT CUSHION LOCK HOOK
73350C
6.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
7.REMOVE REAR SEATBACK ASSEMBLY RH
58416K
8.REMOVE REAR NO. 2 FLOOR BOARD
65351A
9.REMOVE BATTERY HOLE COVER
64779
10.REMOVE SPARE WHEEL COVER TRAY
58387B
11.REMOVE REAR FLOOR FINISH PLATE
12.SEPARATE REAR SEATBACK BOARD CARPET ASSEMBLY LH
58577E
13.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE
62331C
14.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Disconnect the rear door opening trim weatherstrip RH.
67917A
15.REMOVE REAR DOOR SCUFF PLATE RH
58466J
16.REMOVE NO. 2 BATTERY SERVICE COVER BOARD (for HV Model)
71303C
17.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY RH
73705
18.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
81330
19.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
62551F
20.REMOVE REAR SEAT SIDE GARNISH RH
64730B
21.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
62470A
22.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH
897B0A
23.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER
Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.
If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
Remove the 2 bolts.
Disengage the 2 guides.
Disconnect the connector to remove the tire pressure warning ECU and receiver.