RM38N0EC _56 Audio / Visual / Telematics _111825 PARK ASSIST / MONITORING _0500531 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Avoid any impact to the blind spot monitor sensor.

·

Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.



HINT:
·

The blind spot monitor beam axis confirmation is performed to confirm whether the sensor beam axis is correct, and to adjust the beam axis by using a reflector.

·

The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is perpendicular to the floor surface (+/- 2.2°) by using a digital angle gauge, and that the sensor is 46 to 54° from the line parallel to the vehicle center line.



PROCEDURE

Hide 88172 1.INSTALL BLIND SPOT MONITOR SENSOR LH

a.

Connect the connector.


b.

Install the blind spot monitor sensor LH with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88162 2.INSTALL BLIND SPOT MONITOR SENSOR RH

HINT:

Use the same procedure as for the LH side.


Hide 5. BSM ECU DATA WRITE

NOTICE:

BSM ECU data write can only be performed when the beam axis adjustment value is able to be saved to the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SENSOR>ADJUSTMENT