AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK
Make sure that the customize settings are set to default when performing the automatic light control system operation check.
Turn the ignition switch to ON.
Turn the light control switch to the AUTO position.
Cover the automatic light control sensor.
Check that the taillights and low beam headlights come on.
Uncover the automatic light control sensor.
Check that the low beam headlights and taillights turn off.
LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK
Make sure that the customize settings are set to default when performing the light auto turn-off system operation check.
Close all of the doors.
Turn the ignition switch to ON.
Turn the taillights, low beam headlights, high beam headlights, front fog lights and rear fog lights on.
Turn the ignition switch off.
Open the driver door.
Check that all of the lights turn off immediately.
DAYTIME RUNNING LIGHT SYSTEM OPERATION CHECK(w/ Daytime Running Light)
Turn the ignition switch to ON (READY).
Turn the light control switch to the tail or AUTO position (with the low beam headlights not turned on via the automatic light control system).
Release the parking brake.
Check that the daytime running lights come on.
WIPER-LINKED LOW BEAM HEADLIGHT CONTROL SYSTEM OPERATION CHECK
Turn the ignition switch to ON.
Shine a light on the automatic light control sensor.
If troubleshooting is being performed in a bright area, such as outside on a sunny day, it will not be necessary to perform this step.
Turn the light control switch to the AUTO position.
Operate the front wipers for 10 seconds or more (except MIST or washer-linked wiper operation) and check that the low beam headlights*1 or high beam headlights*2 illuminate.
*1: Dimmer switch not high position
*2: Dimmer switch high position
DOOR MIRROR FOOT LIGHT CONTROL OPERATION CHECK (w/ Door Mirror Foot Light)
The operation and condition of this control are described below.
| Operation | Condition |
|---|---|
| Fade in and illuminate constantly | When any of the following conditions is met, the lights fade in and illuminate constantly:
·
A key is detected in the actuation area. ·
Any door is unlocked when the ignition switch is off and all of the doors are closed. |
| Illuminate for 15 seconds, and then fade out | When any of the following conditions is met, the lights illuminate for 15 seconds, and then fade out:
·
An actuation area-linked function is used.* ·
Any door is unlocked when the ignition switch is off and all of the doors are closed. |
| Fade out immediately | When the following condition is met, the lights fade out immediately:
·
The ignition switch is turned from off to ON. ·
A key is not detected in the actuation area. ·
All doors are locked when all doors are closed and any door is unlocked. |
*: When the lights are on, the lights fade out approximately 3 seconds after the key leaves the actuation areas around the doors.
MANUAL HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK
Turn the ignition switch to ON.
Turn the headlights on.
Turn the headlight leveling switch to "0".
Check that the headlight beam level changes when the headlight leveling switch is operated.