The steering sensor receives the turn signal switch information and controls the turn signal lights.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / Steering Angle Sensor / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Turn Signal Switch (Right) | Turn signal switch (right turn position) signal | OFF or ON | OFF: Turn signal switch not in right turn position
ON: Turn signal switch in right turn position |
- |
| Turn Signal Switch (Left) | Turn signal switch (left turn position) signal | OFF or ON | OFF: Turn signal switch not in left turn position
ON: Turn signal switch in left turn position |
- |
| Cornering Light/Front Side Illuminate Light Switch | Turn signal switch (full turn) signal | OFF or ON | OFF: Turn signal switch not in left or right turn position
ON: Turn signal switch in left or right full turn position |
- |
| Tester Display |
|---|
| Turn Signal Switch (Right) |
| Turn Signal Switch (Left) |
| Cornering Light/Front Side Illuminate Light Switch |
Normal conditions listed above are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the turn signal switch.
Inspect the turn signal switch.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the steering wheel switch housing.
Inspect the steering wheel switch housing.
| Proceed to |
|---|
| OK |
| NG |
OK
NG