K121 CVT CONTINUOUSLY VARIABLE TRANSAXLE FLUID REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during CVT fluid replacement are shown below.
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| CVT fluid | ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly | ( 202409,999999,_52,_138176,_0584691,RM100000002NRHB,)
|
| Air bleed oil pump with motor assembly | Stop and start system | (202409,999999,_51,_083056,_0402418,RM100000002NSFT,)
|
PROCEDURE
53895B
1.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
53896B
2.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
51420
4.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
53737D
5.REMOVE FRONT FENDER APRON SEAL LH
6.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE FLUID
7.ADD SPECIFIED AMOUNT OF FLUID
8.BLEED AIR FROM OIL PUMP ASSEMBLY
9.ADJUST FLUID TEMPERATURE (when Using the GTS)
10.ADJUST FLUID TEMPERATURE (when Not Using the GTS)
11.ADJUST FLUID LEVEL
12.PERFORM FLUID THERMAL DEGRADATION ESTIMATE RESET
- NOTICE:
-
If approximately 50% or more of the CVT fluid has been replaced during a repair of the transaxle or a similar operation, perform ATF Thermal Degradation Estimate Reset.
13. REBUILD WORK
53737D
14.INSTALL FRONT FENDER APRON SEAL LH
51420
15.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
51441
16.INSTALL NO. 1 ENGINE UNDER COVER
53896B
17.INSTALL FRONT FENDER FRONT SPLASH SHIELD LH
53895B
18.INSTALL FRONT FENDER FRONT SPLASH SHIELD RH