Use the same procedure for the RH and LH sides.
The procedure below is for the LH side.
69780E
1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
|
Install in this Direction |
Attach the clamp and install the rear door inside locking cable assembly as shown in the illustration.
69740E
2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
|
Install in this Direction |
Attach the clamp and install the rear door lock remote control cable assembly as shown in the illustration.
69038A
3.INSTALL REAR DOOR LOCK COVER SUB-ASSEMBLY LH
Attach the claw.
|
Install in this Direction |
Attach the claw and install the rear door lock cover sub-assembly LH as shown in the illustration.
69318D
4.INSTALL DOOR LOCK WIRING HARNESS SEAL
When reusing the removed rear door lock with motor assembly LH, be sure to replace the door lock wiring harness seal on the connector with a new one.
Keep the door lock wiring harness seal of the connector free from grease and dust, etc.
Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water to enter the connecting part. This may result in a malfunction of the rear door lock with motor assembly LH.
When reusing rear door lock with motor assembly LH:
Install a new door lock wiring harness seal to the rear door lock with motor assembly LH.
69060A
5.INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY LH
Apply MP grease to the sliding parts of the rear door lock with motor assembly LH.
| *a | Release Plate |
|
Install in this Direction |
Connect the rear door lock with motor assembly LH to the release plate of the rear door outside handle frame sub-assembly LH, and set it to the rear door panel.
Make sure that the release plate of the rear door outside handle frame sub-assembly LH is securely connected to the rear door lock with motor assembly LH.
Using a T30 "TORX" socket wrench, install the front door lock with motor assembly LH with the 3 "TORX" screws.
69804
6.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
68104
7.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
67408E
8.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68152C
9.INSTALL REAR DOOR GLASS RUN LH
67674A
10.INSTALL REAR DOOR FRAME GARNISH LH
67842E
11.INSTALL REAR DOOR SERVICE HOLE COVER LH
68199
12.INSTALL REAR DOOR REAR BELT SEAL LH
68197A
13.INSTALL REAR DOOR FRONT BELT SEAL LH
68174A
14.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
67604
15.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
16.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74646
17.INSTALL DOOR ASSIST GRIP COVER LH
69278C
18.INSTALL REAR DOOR INSIDE HANDLE BEZEL LH
19.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
20. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
21. INITIALIZE POWER WINDOW CONTROL SYSTEM
22. CHECK POWER WINDOW CONTROL SYSTEM
23. CHECK POWER DOOR LOCK CONTROL SYSTEM