The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tire pressure warning receiver removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Tire pressure warning ECU and receiver | ·
ID Registration ·
Initialization ·
Tire Position Identification |
Tire Pressure Warning System | ( 202409,999999,_53,_083075,_0403331,RM100000002NGWW,)
|
1.REMOVE REAR SEAT ASSEMBLY
73705
2.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
58410B
3.REMOVE DECK BOARD ASSEMBLY
58416K
4.REMOVE REAR NO. 2 FLOOR BOARD
58386
5.REMOVE REAR FLOOR FINISH PLATE
58577E
6.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE
62331C
7.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
Pull back the No. 3 rear seat side garnish RH so that the rear door opening trim weatherstrip RH can be removed.
Use the same procedure described for the LH side.
62551F
8.REMOVE REAR SEAT SIDE GARNISH RH
Use the same procedure described for the LH side.
73708A
9.REMOVE TETHER ANCHOR BRACKET SET
58460D
10.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY
64740E
11.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
62470A
12.REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH
Use the same procedure described for the LH side.
897A0A
13.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER
Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.
If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
|
Bolt |
|
Connector |
Remove the bolt.
Detach the 2 guides and tire pressure warning ECU and receiver.
Disconnect the connector.