RM36D0EC _51 Engine / Hybrid System _083060 M20D-FKS FUEL _0403637 FUEL PRESSURE SENSOR(for High Pressure) A

M20D-FKS FUEL  FUEL PRESSURE SENSOR(for High Pressure)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89458 1.INSTALL FUEL PRESSURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the fuel pressure sensor.

Click hereEngine / Hybrid System>M20D-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A434655C01
0.688,0.333 0.844,0.333 0.844,0.333 1.052,0.635 true 2.458,0.51 2.302,0.51 2.302,0.51 2.063,0.958 true 0.49,0.24 0.688,0.406 0.198,0.167 10 true *a 2.479,0.396 2.656,0.563 0.177,0.167 10 true *b
*a Cutout (Fuel Delivery Pipe)
*b Cutout (Fuel Pressure Sensor)


Temporarily install a new fuel pressure sensor to the fuel delivery pipe.

NOTICE:
·

Make sure that the cutout of the fuel delivery pipe is aligned with the cutout of the fuel pressure sensor.

·

Do not allow dust or dirt to enter the sensor.

·

If a fuel pressure sensor is dropped or struck, replace it with a new one.




b.
A434656C01
0.708,0.25 0.844,0.25 0.844,0.25 1.094,0.625 true 2.604,0.615 2.427,0.615 2.427,0.615 2.188,0.969 true 0.521,0.156 0.688,0.333 0.167,0.177 10 true *a 2.646,0.51 2.875,0.698 0.229,0.188 10 true *b
*a Cutout (Fuel Pressure Sensor)
*b Cutout (No. 1 Fuel Pressure Sensor Holder)


Temporarily install the No. 1 fuel pressure sensor holder to the fuel delivery pipe.

NOTICE:

Make sure that the cutout of the fuel pressure sensor is aligned with the cutout of the No. 1 fuel pressure sensor holder.



c.

Install the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Connect the connector to the fuel pressure sensor.


Hide 4. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART