Use the same procedure for the RH and LH sides.
Use the same procedure described for the LH side.
85720D
1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH to the front door window regulator sub-assembly LH with the 3 "TORX" screws.
A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
69804
2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
68104
3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
67408E
4.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68152C
5.INSTALL REAR DOOR GLASS RUN LH
67674A
6.INSTALL REAR DOOR FRAME GARNISH LH
67842E
7.INSTALL REAR DOOR SERVICE HOLE COVER LH
68199
8.INSTALL REAR DOOR REAR BELT SEAL LH
68174C
9.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
67604
10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
11.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74646
12.INSTALL DOOR ASSIST GRIP COVER LH
69278C
13.INSTALL REAR DOOR INSIDE HANDLE BEZEL LH
14.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
15. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
16. INITIALIZE POWER WINDOW CONTROL SYSTEM
17. CHECK POWER WINDOW CONTROL SYSTEM