RM36D0EC _52 Drivetrain _083071 AXLE AND DIFFERENTIAL _0402906 REAR DIFFERENTIAL CARRIER ASSEMBLY A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 52391A 1.INSTALL REAR DIFFERENTIAL SUPPORT

a.

Install the rear differential support to the rear differential carrier assembly with 4 new bolts.

Torque:
72 N*m (734 kgf*cm, 53 ft.*lbf)


Hide 2.INSTALL REAR NO. 1 DIFFERENTIAL SUPPORT

a.

Install the rear No. 1 differential support to the rear differential carrier assembly with 2 new bolts.

Torque:
55 N*m (561 kgf*cm, 41 ft.*lbf)


b.

Install the rear upper differential mount stopper to the rear No. 1 differential support.


Hide 3.INSTALL REAR NO. 2 DIFFERENTIAL SUPPORT

a.

Install the rear No. 2 differential support to the rear differential carrier assembly with 2 new bolts.

Torque:
55 N*m (561 kgf*cm, 41 ft.*lbf)


b.

Install the rear upper differential mount stopper to the rear No. 2 differential support.


Hide 41110 4.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

NOTICE:
·

Do not damage the contact surface when installing the rear differential carrier assembly with differential support.

·

The remaining oil may leak out when installing the rear differential carrier assembly with differential support.

·

Securely support the rear differential carrier assembly with differential support while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly with differential support.

·

Install the bolts and nuts with the rear differential carrier assembly with differential support secured.



a.

Support the rear differential carrier assembly with a transmission jack or equivalent.


b.

Temporarily install the rear differential carrier assembly with differential support to the rear suspension member sub-assembly with the 2 rear lower differential mount stoppers and 3 new bolts.

C403124N01
1.854,1.885 2.01,2.083 0.156,0.198 10 true A 4.479,1.469 4.635,1.667 0.156,0.198 10 true A 6.031,2.417 6.188,2.615 0.156,0.198 10 true B


c.

Tighten the 2 bolts (A).

Torque:
86 N*m (877 kgf*cm, 63 ft.*lbf)

NOTICE:

Do not tighten the bolts with the inner cylinder or rear differential mount cushion tilted.



d.

Tighten the bolt (B).

Torque:
130 N*m (1326 kgf*cm, 96 ft.*lbf)

NOTICE:

Do not tighten the bolts with the inner cylinder or rear differential mount cushion tilted.



e.

Install the breather tube.


f.

Install the wire harness clamp bracket with the bolt.

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)


g.

Connect the 2 connectors.


h.

Connect the 2 harness clamps.


Hide 42330 6.INSTALL REAR DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.