RM3660EC _58 Vehicle Interior _080741 SUPPLEMENTAL RESTRAINT SYSTEMS _0392911 SIDE AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR  INSTALLATION  


PROCEDURE

Hide 8983AA 1.INSTALL SIDE AIRBAG PRESSURE SENSOR

a.

Check that the ignition switch (for Gasoline Model) or power switch (for HV Model) is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
for NR Series:
·
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


except NR Series:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.




c.
B520902C01
1.948,0.927 2.49,0.927 true 2.448,0.833 2.656,1.031 0.208,0.198 10 true *a
*a Stopper


Insert the side airbag pressure sensor stopper into the door hole, engage the claw and install the side airbag pressure sensor to the front door panel with the nut.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the side airbag pressure sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the side airbag pressure sensor, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

·

Make sure that the side airbag pressure sensor stopper is securely inserted into the door hole.

·

Keep the stud bolt and waterproof rubber seal free of foreign matter.




d.

Connect the connector to the side airbag pressure sensor.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (except NR Series Engine)>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



e.

Check that there is no looseness in the installed parts of the side airbag pressure sensor.


Hide 4.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Hide 5.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Hide 64490 9.INSTALL LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY (for M20F-FXS, M20G-FXS)

Hide 13. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART