RM3660EC _58 Vehicle Interior _143816 MY SETTINGS _0600571 MY SETTINGS SYSTEM J

MY SETTINGS  MY SETTINGS SYSTEM  Driver Identification Method cannot be Set  


DESCRIPTION

When a setting assignment using the multi-display is performed, the smart entry and start system (for Start Function), digital key system*1, audio and visual system*2*3 and navigation system*2*4 will use the device when performing a search. If detected, settings can be assigned. If there is no detection, it is suspected that the radio and display receiver assembly or each system is malfunctioning.

*1: for vehicles which display the assigned settings of Digital key system on the multi-display

*2: for vehicles which display the assigned settings of Bluetooth devices on the multi-display

*3: w/ Audio and Visual System

*4: w/ Navigation System


CAUTION / NOTICE / HINT

NOTICE:

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.


PROCEDURE

1.CHECK THE SYMPTOMS
a.

Check the problem symptoms.


Result:
Result Proceed to
Assignment of settings cannot be performed using the electrical key transmitter sub-assembly. A
Assignment of settings cannot be performed using the digital key. B
Assignment of settings cannot be performed using the Bluetooth device. C



A

2.CHECK SMART ENTRY AND START SYSTEM (for Start Function)

B

4.CHECK RECALL OPERATION (Assigned Settings Inspection)

C

5.CHECK RECALL OPERATION (Assigned Settings Inspection)
3.CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
a.

Temporarily replace the main body ECU (multiplex network body ECU) with a new one.

HINT:

Refer to Service Bulletin.



b.

Check if settings can be assigned again to an electrical key transmitter sub-assembly.


OK:

All of the electrical key transmitter sub-assemblies could be registered to the new certification ECU (smart key ECU assembly) successfully.


Result:
Proceed to
OK
NG



OK

END (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) WAS DEFECTIVE)

NG

4.CHECK RECALL OPERATION (Assigned Settings Inspection)
a.

Check if settings can be assigned again to an electrical key transmitter sub-assembly.


OK:

Settings can be assigned


Result:
Proceed to
OK
NG



OK

NG

2.CHECK SMART ENTRY AND START SYSTEM (for Start Function)
5.CHECK RECALL OPERATION (Assigned Settings Inspection)
a.

Check if settings can be assigned again to an electrical key transmitter sub-assembly.


OK:

Settings can be assigned


Result:
Result Proceed to
OK (w/ Audio and Visual System) A
OK (w/ Navigation System) B
NG C



A

B

C

2.CHECK SMART ENTRY AND START SYSTEM (for Start Function)