Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Check that the following Wi-Fi connection settings are set as follows:
"Wi-Fi" is set to on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the conditions and procedure for establishing a "Wi-Fi" connection, and perform the "Wi-Fi" connection procedure again.
As there may be wave interference, disconnect other "Wi-Fi" compatible devices or "Bluetooth" compatible devices before establishing a "Wi-Fi" connection.
A "Wi-Fi" connection can be established manually or automatically.
There are 2 ways to establish a manual "Wi-Fi" connection. Connecting by searching for a "Wi-Fi" access point, and connecting by entering an SSID and password.
Even though an automatic connection is enabled, a connection can be established only when a "Wi-Fi" access point with the same SSID and password that were used for a previous connection exists.
| Result | Proceed to |
|---|---|
| "Wi-Fi" connection can be established. | A |
| "Wi-Fi" connection cannot be established. | B |
A
B
Check the device to be connected via "Wi-Fi".
Considering the radio wave environment around the vehicle, move the vehicle and establish a "Wi-Fi" connection.
| Result | Proceed to |
|---|---|
| The in-vehicle device is trying to connect to the "Wi-Fi" access point of a portable device such as a mobile "Wi-Fi" router, tethering device, etc. | A |
| The in-vehicle device is trying to connect to a "Wi-Fi" access point other than a portable device. | B |
A
B
Bring a portable device to be used to establish a "Wi-Fi" connection near the in-vehicle device, and perform "Wi-Fi" connection again.
Considering the radio wave environment around the vehicle, move the vehicle and establish a "Wi-Fi" connection.
Depending on the type of the portable device, customer operation such as internet sharing, tethering settings, etc., may be required whenever establishing a "Wi-Fi" connection.
| Result | Proceed to |
|---|---|
| "Wi-Fi" connection can be established. | A |
| "Wi-Fi" connection cannot be established. | B |
A
B
Move the vehicle to an access point where "Wi-Fi" connection can be established normally with other vehicles, and perform the "Wi-Fi" connection procedure again.
When the in-vehicle device is connected to an outside "Wi-Fi" access point, the "Wi-Fi" connection will be disconnected if leaving the radio wave service area.
This function is not designed to be used while driving. Use this function only when the vehicle is stopped.
| Result | Proceed to |
|---|---|
| "Wi-Fi" connection can be established. | A |
| "Wi-Fi" connection cannot be established. | B |
A
B
Bring a well-known portable device such as a mobile "Wi-Fi" router, tethering device, etc., near the in-vehicle device, and perform the "Wi-Fi" connection procedure again.
Considering the radio wave environment around the vehicle, move the vehicle and establish a "Wi-Fi" connection.
Depending on the type of the portable device, customer operation such as internet sharing, tethering settings, etc., may be required whenever establishing a "Wi-Fi" connection.
| Result | Proceed to |
|---|---|
| "Wi-Fi" connection can be established. | A |
| "Wi-Fi" connection cannot be established. | B |
A
B