TELEMATICS TELEMATICS SYSTEM(for Gasoline Model) VEHICLE CONTROL HISTORY
- NOTICE:
-
Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.
CHECK VEHICLE CONTROL HISTORY
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Telematics / Utility / Vehicle Control History (RoB).
- Body Electrical > Telematics > Utility
-
Tester Display Vehicle Control History (RoB) - 50005 459 55
| Code | Tester Display | Description | Diagnostic Note |
|---|---|---|---|
|
*: for 10.25 Inch Display or 9 Inch Display without RST Switch |
|||
| X2210 | Life Cycle of DCM Backup Battery | When the system detects that the mobilephone battery has reached the end of its lifespan. | ·
The emergency call switch red indicator blinks ·
Replace mobilephone battery
|
| X2211 | Low DCM Backup Battery Charge | When the mobilephone battery charge is low. | - |
| X2601 | Software Inconsistency with ENG/HV Control Module | The VIN number received via CAN communication does not match that stored in the DCM. | ·
The emergency call switch red indicator blinks ·
Perform VIN Synchronization |
| X2214 | Communication Blackout from Power Distribution Controller ECU | Lost Communication with ECM. | Check CAN Communication System
except NR Series(  202304,999999,_57,_080743,_0598531,RM100000002BFV9,)
for NR Series( 202304,999999,_57,_080743,_0598517,RM100000002B6UW,)
|
| X2212 | Diagnostics Communication Flow Failure | Diagnostics communication flow failure (ID, Mode/SID difference). | - |
| X2215 | Non Approval of the Reprograming | User did not approve software update. | - |
| X2216 | Failure of the Reprogramming | User did not approve software update. | - |
| X2217 | Inconsistent Startup Software | Software writing succeeded, but started software does not match package. | - |
| X21D4* | Reprograming Telematics ECU by OTA Start/Finish | The software update of DCM by OTA is started and completed with success. | - |
CLEAR VEHICLE CONTROL HISTORY
- NOTICE:
-
By performing this procedure, all stored Vehicle Control History will be cleared.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Telematics / Utility / Vehicle Control History (RoB).
- Body Electrical > Telematics > Utility
-
Tester Display Vehicle Control History (RoB) - 50005 459 55
According to the display on the GTS, clear the Vehicle Control History (RoB).